mbw
Full Access Member
I've never seen that on an LR4, but ok... I would need the overhead lights. Can't find the "other listing" though. I like the idea of having the CANBUS supported ballasts.
LR4 Interior LED Lights
- Thread starter jlaw008
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I've never seen that on an LR4, but ok... I would need the overhead lights. Can't find the "other listing" though. I like the idea of having the CANBUS supported ballasts.
umbertob
Full Access Member
The only bulbs that will give you grief are the front door ones (hopefully this CANBUS compatible set takes care of that), you don't need special ones anywhere else.
backcountryLR4
Full Access Member
I can confirm(or add my confirmation) that these full replacement units for the door card lights work perfectly:
http://www.powerfuluk.com/vehicles/...-4-led-door-courtesy-light-assembly-pair.html
The cheap LEDs I purchased for every other light minus vanity and glovebox, worked everywhere except the two front doors. Tried all recommended tricks to no avail.
Ordered these two from Powerful UK and just pulled out the whole unit from the clip, plugged in the replacement, closed the door and opened it again and voilà! Car was off, no tricks, they just worked. I did have to close and open each door after installing. It did not light up as soon as it was plugged in.
Did the install in the noonday sun in the parking lot at my office, but as far as I can tell so far they seem a lot brighter than the cheapos in the rear doors.
It seems worth the $42 to have everything working as it should.
http://www.powerfuluk.com/vehicles/...-4-led-door-courtesy-light-assembly-pair.html
The cheap LEDs I purchased for every other light minus vanity and glovebox, worked everywhere except the two front doors. Tried all recommended tricks to no avail.
Ordered these two from Powerful UK and just pulled out the whole unit from the clip, plugged in the replacement, closed the door and opened it again and voilà! Car was off, no tricks, they just worked. I did have to close and open each door after installing. It did not light up as soon as it was plugged in.
Did the install in the noonday sun in the parking lot at my office, but as far as I can tell so far they seem a lot brighter than the cheapos in the rear doors.
It seems worth the $42 to have everything working as it should.
Last edited:
mbw
Full Access Member
I emailed them and asked about the 15 pc (vs the 12 pc) kit. They said it wasn't listed, but fixed it.
http://www.powerfuluk.com/land-rover-discovery-3-4-led-interior-light-upgrade-kit-16-pc-white.html
http://www.powerfuluk.com/land-rover-discovery-3-4-led-interior-light-upgrade-kit-16-pc-white.html
backcountryLR4
Full Access Member
Having them all round would turn the interior to the surface of the sun. (They are super bright...)
mbw
Full Access Member
I already ordered it!
I want them for the lower power draw and heat, but also for more light. Will be great for camping. I will try to get some good before/after pictures.
backcountryLR4
Full Access Member
I already ordered it!
Did my cheapo Yorkim LED (20 for 19.98) install during the day so don't have good before/after pics on those. They were still brighter than the incandescent stock bulbs and feels like a clean white(6500k).
Below pic shows one of those 6500k Yorkim bulbs in the rear door card and the replacement unit in the front. The light projected on the ground tells it all for a brightness comparison. The PowerfulUK unit does seem a bit warmer than the other bulbs maybe 5000k, but still considerably better than stock.
stufrowin
Full Access Member
- Joined
- Mar 14, 2015
- Posts
- 111
- Reaction score
- 25
Confirmed superbrightleds.com ones listed above with CANBUS work on front doors just installed them.
mbw
Full Access Member
I prefer 4000 - 5000k range anyway. Kit shipped, just waiting.
got a question
I changed the reverse light bulb with led one, and tested it by "turn ACC ON, step on brake and shift to reverse" several times yesterday evening
then this morning I have engine light on
any idea before I go to check the code?
Thanks
I changed the reverse light bulb with led one, and tested it by "turn ACC ON, step on brake and shift to reverse" several times yesterday evening
then this morning I have engine light on
any idea before I go to check the code?
Thanks
