farmerfred
New Member
Have problems with Aircon blowing hot air. Had gas check carried out this morning and gas was low only 450g instead of 700g. System vacuum checked and recharged.
Despite this no cold air. Fault check carried out iaw manual. Fault code 00 so no fault.
When LO switch pressed compressor note changes which suggests it is pumping. Does anybody know if there are sensors which shut of warm air(heater) to allow only cold air. Cannot find circuit diagram anywhere.
any help most welcome.
Despite this no cold air. Fault check carried out iaw manual. Fault code 00 so no fault.
When LO switch pressed compressor note changes which suggests it is pumping. Does anybody know if there are sensors which shut of warm air(heater) to allow only cold air. Cannot find circuit diagram anywhere.
any help most welcome.