Raising the Vehicle via GAP Tool

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

pabs406

Well-Known Member
Joined
Aug 28, 2015
Posts
69
Reaction score
10
Hi Guys. So I finally pulled the trigger on a GAP tool. I took some measurements from the ground to the bottom of the wheel well after I did a +47 lift. The fronts measured 34.75” and the rears 37” in off-road mode.

This was an increase of .75” in the front and 2” in the rear from off-road mode at the +0 lift.

Is there a way to gain more lift in the front? I’d love to get that extra clearance going through some of the off-shoots.

Is there a way to manipulate the tool? Or is the only way to install lift rods and tune with the tool?
 
Last edited:

Houm_WA

Full Access Member
Joined
Jan 6, 2006
Posts
3,933
Reaction score
254
You're going about it incorrectly. You have to check your calibration values (maybe it was live values, I don't remember) and see how much buffer you have against the max value, then raise each corner that amount.
 

Latest posts

Members online

No members online now.

Forum statistics

Threads
36,201
Posts
217,349
Members
30,461
Latest member
okamgba1463
Top