Search results
-
M
I'll be back...
Sadly, I'm about to be turning in my LR4. I would not have been able to own it for this long without this forum and becoming a mechanic, so I wanted to say thank you for the help and entertainment. We decided we are going to move to a Volvo, but I'm sure that someday down the line I will need my... -
M
Selling LR3/4 Tools and Parts: GAP Tool, Skid Plate, Snow Tires, Brake Lines, Timing Chain Tools
Its looking likely that I will be selling my LR4. If the sale goes through, I will have the following tools and parts for sale: 1. GAP IID bluetooth tool. $400 2. Timing Chain Replacement Tool Sets (2x) (used) $50 each, $75 both 3. Injector Pulling Tool (used) $20 4. Oil Change Vacuum Pump... -
M
Selling LR4 Near Boston
Sadly looking to sell my LR4. Sumatra Black (has a tint of blue in it) with tan interior. Interior is flawless. Its seen dirt roads and pavement, never trails. The truck is stock, with the additional of a land rover skid plate and custom roof rack rails. Xenon headlights, tow package, rear... -
M
Steel Brake Lines Replacement?
My LR4 is in the shop having the front LCA's replaced. The service advisor told me that my rear steel (the hard lines) brake lines "don't look too good" and warned that a hard braking could blow the line. Anyone ever had their hard rear brake lines replaced? Is it DIY-able? -
M
Removing rusted-in OEM tow hitch
My tow hitch (the tow hitch receiver, I guess you would call it) is rusted in place and I cannot get it out. Tried lubing the internals, no dice. Any way to get this thing off? Angle grinder and install one of the frame mounted receiver? -
M
Slop in Steering. Steering Rack Replacement?
My 2012 LR4 has 80,000 miles. I haven't replaced the front control arms yet (ugh), but noticing a few things on the highway. 1. When I start driving on the high (with a "cold" car), I get a little bit of vibration, which disappears after a few minutes. Slight, but noticeable. 2. On the... -
M
Rear brake caliper slider pins loose?
I had to replace my rear brakes because one pad looked like it was down to the metal and sounded horrible. When I got the wheels off, I realized this: On the left rear caliper, the bottom caliper slider pin did not have a bolt in it... the caliper was being supported by just the top pin. On... -
M
LR4 Right Xenon Headlight Assembly
Used LR4 right headlight assembly. It's a xenon with AFS, but works fine with cars that do not have AFS. Good, used condition. Small scuff on bottom of the lens, but in good condition overall. $300 shipped CONUS. PM me if you are interested. -
M
LR4 Halogen Headlights w/ LED's
I've got a set of OEM LR4 headlight assemblies. Halogen, the LED 'halo' lights all work. Great condition, no major scratches or scuffs. Make an offer, I will separate them. -
M
Are LR4's actually bi-xenon?
I just got done upgrading my 2012 LR4 to xenon headlights. I was reading the workshop manual, and it talked about how the xenon headlights were bi-xenon headlights. That implies that the xenon bulbs put out more light (some solenoid inside the bulb) when you switch to high beams. From the... -
M
Engine Won't Crank... Ideas?
2011 LR4. Helping a buddy with his LR4 that isn't starting. The starter motor relay is not getting a signal to start the engine when we push the push to start the button. -If we jump the starter relay, the starter kicks in and will crank the engine-- so we know the starter is wired properly... -
M
5.0L Natural vs Supercharged
Asking for a friend. We have a blown 5.0L supercharged engine on a 2011 Range Rover Sport. Can we put a naturally aspirated long block into the truck, bolt the supercharger back on top? 5.0 SC engines are a lot harder to find than the naturally aspirated engines.- mklinker
- Thread
- Replies: 6
- Forum: Range Rover
-
M
You pull this out of your #7 cylinder...
See attached... What do you think happened? Not my LR4, but a friends RRS with the 5.0SC. Engine is seized, started pulling spark plugs, found this. -
M
Light Bar Wiring Routing
Lets say I wanted to put a light bar on my roof rack. Is there any way for me to run the wires without drilling my roof? Anyone have experience with this? Thanks- -
M
Steering Squeak / Clunk
2012 LR4, 72,000 miles. Yes I know I have an LR4 in an LR3 forum, but the steering rack/everything is the same, and no one on the LR4 forum has chimed in. When I am driving, there is a squeaking noise coming from the steering column, both when I am turning the wheel at slow speeds, hitting... -
M
LR4 Steering Squeak / Clunk
2012 LR4, 72,000 miles. When I am driving, there is a squeaking noise coming from the steering column, both when I am turning the wheel at slow speeds, hitting small bumps at slow speed, or coming to a complete stop. It is not the normal clock spring whining. I can sometimes make it squeak... -
M
LR4 Starter Motor Hose Attachment
I noticed that the starter on the LR4 has a hose nipple on it--where does it go? What is it used for? There is no return hose... -
M
How to post to Classifieds?
I'm a contributing member of the community here... How do I go about getting access to post to the classifieds sections?- mklinker
- Thread
- Replies: 2
- Forum: Introduction
-
M
Installing LR3 Xenon's into an LR4 with halogens?
I have a set of LR3 xenon headlights with ballast. My 2012 LR4 has the standard halogen bulbs, and I hate that my LR3 had Xenons and my newer, nicer LR4 only has halogens. Has anyone heard of swapping the LR3 bulbs and ballast into an LR4 headlight unit?
