Search results
-
Suspension Fault — Temp Sensor?
U210A-16(AF) - Temperature Sensor - Circuit voltage below threshold Showed up on my drive home, it'd go away after a bit, then come back up, and then go away, and come back. No restricted mode or anything like that... -
Another Coolant Leak - Occasional White Vapor at Idle? 2015 SCV6
I think I might have a small coolant leak somewhere, but can't trace it. All coolant work was done within the last 6 months by LR indy—rear+ front pipes, water pump, thermostat housing, hoses etc. No dripping on the floor, and not noticing any sweet smell either. Coolant loss was very minimal... -
Engine Rattling on Cold Start (Timing chain tensioner?)
2015 SCV6 LR4 (74k miles) has a slight clicking/ticking noise when idling after cold start (videos included). Once the car warms up it's gone. No codes, and I suspect it's a timing chain tensioner, but thought I'd ask in the event that I can catch something early. I took the engine cover off so... -
18" steelies without spacers for 2015 LR4 SCV6
I've been doing some searching around for 18" steelies for my 2015 LR4 SCV6 but can't seem to find anything other than the Tuffant 18"s that will work without spacers. Has anyone found anything like this or something that's comparable? I'm not overly excited to run it with spacers, but I'm... -
18" vs 19" for All Terrain Tires
What are peoples thoughts on AT tires on 18" vs 19"? I've seen and hear a lot of talk about switching to 18" wheels as it opens up a much wider array of tire choices. I'm curious whether there's a big reason to change out the wheels other than options? I'm sure sidewall size etc. will be... -
Rattling/Vibrating/Grinding/Ringing noise when turning at low RPM
2015 LR4 with 71k miles on it makes a strange grinding/ringing noise when I turn left or right with low RPM (~1500), if I accelerate a little harder out of a turn it doesn't happen. It only occurs, and only sporadically when turning through low RPM. The noise almost sounds like an exhaust heat... -
"Air Suspension Not In Customer Mode" when trying to calibrate
Folks, trying to calibrate my suspension on my 2015 LR4 using the Gap IID tool, and every time I’m just about to calibrate I get the “air suspension not in customer mode” warning on the dash. I did go through the whole routine disabling build mode, and then re-enabling EAS… but then when I go...
