Facundo
New Member
My A/C stopped blowing cold. Everything "seems" to work.
I was going to add freon but I noticed that the pressure is very high, like almost 100 PSI high.
I made sure to run the engine, wait until it was at normal running temperature. Then I plugged in the gauge in the low line and it reads ~95 PSI. External temperature was at about 75 F. I tried with "auto" mode in the ATC, with and without ECON. I tried in Manual at full blast too.
Any suggestions on how I can troubleshoot this further before I decide to replace the Compressor?
Thanks!
I was going to add freon but I noticed that the pressure is very high, like almost 100 PSI high.
I made sure to run the engine, wait until it was at normal running temperature. Then I plugged in the gauge in the low line and it reads ~95 PSI. External temperature was at about 75 F. I tried with "auto" mode in the ATC, with and without ECON. I tried in Manual at full blast too.
Any suggestions on how I can troubleshoot this further before I decide to replace the Compressor?
Thanks!