BarryM21
Member
I have a 2012 LR4 and here are some of the facts.
Fault says Normal Height Available only (GAP IID Tool)
- Fault Code is C1A34-01 (AF) Rear Right Corner Valve - General Failure Information - General Electrical Failure
I occasionally get an
C1A36-01 (2E) Exhaust Valve - General electrical Failure. Not sure if these are related.
Car wont go up or down, or at least it starts and immediately gives the fault message.
Things to note:
I'm running an Arnott Compressor
I've replaced the rear right valve block (didn't fix the problem)
Here's another factor. I've tried a valve test through GAP IID on each of the four corners of the car and the rear right does not go up or down. the other 3 wheels have pretty full range of motion when initiated through the tool, which leads me to believe theres something off with the rear right suspension. The rear right is happy to sit at normal height but that's pretty much it unless I deflate the reservoir, in which case it will go down. I've done a cursory glance at the wiring and everything seems to be as it should be.
Cant quite seem to figure this one out. Maybe the Arnott compressor isnt a good fit. Not sure...
Any thoughts or experience shares are appreciated.
Fault says Normal Height Available only (GAP IID Tool)
- Fault Code is C1A34-01 (AF) Rear Right Corner Valve - General Failure Information - General Electrical Failure
I occasionally get an
C1A36-01 (2E) Exhaust Valve - General electrical Failure. Not sure if these are related.
Car wont go up or down, or at least it starts and immediately gives the fault message.
Things to note:
I'm running an Arnott Compressor
I've replaced the rear right valve block (didn't fix the problem)
Here's another factor. I've tried a valve test through GAP IID on each of the four corners of the car and the rear right does not go up or down. the other 3 wheels have pretty full range of motion when initiated through the tool, which leads me to believe theres something off with the rear right suspension. The rear right is happy to sit at normal height but that's pretty much it unless I deflate the reservoir, in which case it will go down. I've done a cursory glance at the wiring and everything seems to be as it should be.
Cant quite seem to figure this one out. Maybe the Arnott compressor isnt a good fit. Not sure...
Any thoughts or experience shares are appreciated.