Recent content by wlvrn
-
Favorite Roof Rack? (boats, boards and a storage box)
For those of you with roof rack LED bars... what path are you taking to run the power down from the lights to the fuse box? -
Favorite Roof Rack? (boats, boards and a storage box)
I just put on a full length Frontrunner rack. They're amazing products and super-modular. They have tons of rack accessories from lighting to boat mounts to crock pots (seriously). I love mine; it's built strong and is extremely versatile. -
Interior Trim - Removal and Replacement Tips and Tricks
Has anyone removed the passenger side lower right footwell to access the ground screws? I've been having difficulty getting that panel back on due to the angle of the clip retainers. Anyone managed to get this piece back on properly? -
Interior Trim - Removal and Replacement Tips and Tricks
In working on my LR4 for the first time, one of the more interesting things to figure out is how certain pieces of trim are removed or put back on. There's little to no information out there on many of the interior trim pieces; even the Workshop Manual is lacking specifics on various important... -
Everything about tires for LR4/ LR3 with 18" wheels
@backcountryLR4 Yup, that's how mine look as well. I see the weights in my wheels are offset a bit; I'm guessing to avoid the calipers. I was curious when you mentioned this as when I took the car out for the first time for a long drive after having the wheels put on, after about 2 hours on... -
Everything about tires for LR4/ LR3 with 18" wheels
If you snap some photos of the calipers near the pads, I can tell you if that looks similar to what I've got going on. -
Everything about tires for LR4/ LR3 with 18" wheels
Nah, you're the right amount of excited. :) -
Everything about tires for LR4/ LR3 with 18" wheels
Just got off the phone with BFG and they insist that according to their tables, 55 PSI on those KO2s is correct based on the recommended PSIs on the door, the wheel size, tire size and load. I don't pretend to have fully absorbed the mathematics involved, but from what I understand they take... -
Everything about tires for LR4/ LR3 with 18" wheels
I asked if they could clarify their recommendation and this is what I got back. -
Everything about tires for LR4/ LR3 with 18" wheels
So, there's a post by bullmrkt where he mentions some values he tested and what he settled on (42F/48R) so I decided to give that a shot. Just adjusted the pressure and took a little spin and things felt pretty good. I'll let you know more after I put some miles on them at that PSI. -
Everything about tires for LR4/ LR3 with 18" wheels
I emailed BFG to see what their recommendation was for LT265/60R18 KO2 PSI and they got back to me with some pretty high numbers: Anyone else go that high? I've seen a lot of people in this thread with the same size go 42F/48R. -
Everything about tires for LR4/ LR3 with 18" wheels
That's good info to spread around if it's true. -
Everything about tires for LR4/ LR3 with 18" wheels
I hear you on the $$. I found a some caps on Ebay. Not 100% sure these are the exact fit but I have read a few posts saying that 63mm is the correct fit. http://www.ebay.com/itm/272511906717?item=272511906717&viewitem=&vxp=mtr Greg at Johnson Rods also does sell the sensors. I can't speak... -
Everything about tires for LR4/ LR3 with 18" wheels
I've read numerous accounts of the 265/65s a) rubbing at full articulation and b) requiring both the removal of the heat shield and requiring almost full deflation in order to stow them in the full-sized spare area. Also, I've heard a few people comment on the 65s getting in the way of the tow...
