Search results
-
C
Upper and Lower Ball Joints
Have the rave manual. Parts arrived and I am going to get to this next week. The manual highlights a number of special rover tools and what I was looking for is info on using alternatives. I have a C-clamp style of ball joint remover that looks like it will work but if anyone has specific... -
C
Upper and Lower Ball Joints
Mike It is possible that it is actually the lower one but the noise and "squeaking" does appear to be coming from the upper. I checked it out pretty carefully. Is it prudent to change both once it is all apart? C -
C
Upper and Lower Ball Joints
I have a 2000 DII with little over 120,000km that has at least the upper ball joint shot on one side so my assumption is that I would change both at the same time. How big a job is this going to be to do it myself - reasonable DIY experience and tools. Will I be able to get the ball joints... -
C
Headrest Removal
I know how it is supposed to work to remove the headrests on the front seats in a 2000 DII but when it doesn't is there a trick to it. I am putting in some seatcovers and the HR must come off to accomplish this. A quarter turn on all the other little plastic pieces works fine but on one... -
C
OME spring install
Mike I am sticking with the relatively new billsteins for now. Apparently I am within their operating range with the slightly taller springs. The truck had the HD rover springs installed 2 years ago when a winch was mounted o nthe truck. The rear ones are not up to the load I carry so I... -
C
OME spring install
They are OME springs. I think have the front ones figured out. C -
C
OME spring install
Getting ready to install new rear springs. They are the Heavy Load part # 2762 springs. Which end goes up??? The more tightly wound end up or vice versa? It may not even make a difference! C -
C
MAF and SES light
After a long drive to camp and then travelling remote bush roads and trails for 5 days the SES light stayed off the entire time. The diagnosis was bang on and the code reader is clean. Gas consumption even went down. :proud: The fishing was great :biggrin: and I returned to Tornado... -
C
MAF and SES light
New MAF installed. Was in a bit of a rush to get away tomorrow so I paid a premium. About a 7 hour drive tomorrow - time will tell if the light comes back! Off on a fishing trip to North Eastern Ontario. Will update on my return. Thanks to all. C -
C
MAF and SES light
Is this a simple swap then?? Does anything need to be "reprogrammed? Other that the SES light? C -
C
MAF and SES light
My apologies abouyt the vehicle ID. I thought I had it in my profile. It is a 2000 Disco II. A new MAF it is! -
C
MAF and SES light
I have read a number of the posts regarding fault codes P0171 and P0174. The answer is clean and or replace the MAF unit. I have just cleaned mine and will take it for a run tomorrow. If I need to I will order a new MAF. I have had this code a few times this summer and each time it has... -
C
My 1971 Series IIA 88" Restoration
No rush - when you get a chance. I am having trouble finding anyhting that might be suitable and perhaps look right as well. I have two series in rough shape and hope to build one good one. I am right at the bulkhead rebuild stage and hope to have it figured out by month end. I just... -
C
My 1971 Series IIA 88" Restoration
I am redoing my IIA but am behind a little. The bulkhead has been a majorchallenge but once that is ready things should leap forward a bit! What brand are the tires you have? Crash
