pabs406
Well-Known Member
- Joined
- Aug 28, 2015
- Posts
- 69
- Reaction score
- 10
Hi Guys. So I finally pulled the trigger on a GAP tool. I took some measurements from the ground to the bottom of the wheel well after I did a +47 lift. The fronts measured 34.75” and the rears 37” in off-road mode.
This was an increase of .75” in the front and 2” in the rear from off-road mode at the +0 lift.
Is there a way to gain more lift in the front? I’d love to get that extra clearance going through some of the off-shoots.
Is there a way to manipulate the tool? Or is the only way to install lift rods and tune with the tool?
This was an increase of .75” in the front and 2” in the rear from off-road mode at the +0 lift.
Is there a way to gain more lift in the front? I’d love to get that extra clearance going through some of the off-shoots.
Is there a way to manipulate the tool? Or is the only way to install lift rods and tune with the tool?
Last edited: