f1racer328
Full Access Member
I'm honestly more triggered that I need to cut out a lot more of my bumper because of the spacers that are required. Not to mention, shear loads on those spacers probably aren't the greatest idea.
Last night I took the winch tray off and put everything back to stock, minus the crash bar nuts that I punched out.
I was quoted around $1700 for the Prospeed Mount + Bullbar. Without the bullbar was about $1000.
5-7 weeks to ship it to the states.
I'm tempted to just fabricate my own mount at this point. I can get a winch tray laser cut, bent, and powder coated for less than the Terrafirma mount.
It might take me 2 attempts to get the measurements correct but I'm not sure what I'm going to do yet. Pretty disappointed with the Terrafirma.
Orrr I might just throw money at this problem and go with the Prospeed.....
Last night I took the winch tray off and put everything back to stock, minus the crash bar nuts that I punched out.
I was quoted around $1700 for the Prospeed Mount + Bullbar. Without the bullbar was about $1000.
5-7 weeks to ship it to the states.
I'm tempted to just fabricate my own mount at this point. I can get a winch tray laser cut, bent, and powder coated for less than the Terrafirma mount.
It might take me 2 attempts to get the measurements correct but I'm not sure what I'm going to do yet. Pretty disappointed with the Terrafirma.
Orrr I might just throw money at this problem and go with the Prospeed.....