Recent content by russburcham

  1. R

    Coolant pump hose repair

    Good Morning guys, Was wondering if anyone had any advice on installing a new coolant hose --thermostat to water pump- the one that also goes to the resevoir...found a pin hole in mine last night. I was looking around and saw that the bottom connector may be a tight fit... Thanks as...
  2. R

    Ball-Joint quote

    roger that- thanks as always Mike!
  3. R

    Ball-Joint quote

    Hi Mike- about 120k--nasty squeak/grinding sound when turning or going over bumpy roads- The shop owner lifted it and showed me the "play" on the one side that was very noticeable and he recommended doing both-
  4. R

    Ball-Joint quote

    I just got a quote to replace both upper/lower ball joints for the front of my 2001 D2 for $850- with a free alignment. Does this seem reasonable? Thanks for the countless help! Russ
  5. R

    D2 AC fan not working

    same thing happened to me- I had cold air trickling through the vents at hwy speed. went onto ebay found a used bench tested blower and swapped it out (under the glove box) works great now! - pretty simple to do- only 3 screws- hardest part is having to be a contortionist to get to the blower...
  6. R

    crankshaft position sensor question

    four days now and the truck is running strong! thanks to all for your help
  7. R

    Engine Issue

    this sounds similar to a problem I had w/ my 97 disco- no codes and diagnosis from dealer was dirty valves-- ended up to be BS!! Needless to say, I spent $$$$$ having them "clean" them out to no avail...then, I went on to the message boards and people seemed to point me in the direction of the...
  8. R

    crankshaft position sensor question

    strike that code- it was 1158
  9. R

    crankshaft position sensor question

    Thanks for your offer Mike- I just got this msg today and my mechanic already found a used ECU that had higher mileage on it than mine, but was able to take the mileage processor/chip part out so that it still thinks its the original- apparantly, the physical casing at the plug-in area was...
  10. R

    crankshaft position sensor question

    Yes mike, (and thanks for ALL your help btw) I am having starting problems- I was in an earlier post "WILL NOT START IN COLD WEATHER" trying to get help b/c i thought the cold weather was causing my starting problems (cranks but doesn't start)-- if you look in that post, you will find all of the...
  11. R

    will not start in cold weather

    hi joey, yes, it is a land rover ecu (my mechanic ONLY works on land rovers) he was going to swap one out - and he does have the laptop based test book computer. Also gets some of his programs and tech info from Cypress or Crete--or something like that- does this make sense?
  12. R

    crankshaft position sensor question

    if i replace this sensor, do i need to run testbook or not? thanks for the help!
  13. R

    will not start in cold weather

    So my '01 disco w/ 107k miles won't start again. My mechanic has replaced and/or checked my 02 sensors, MAF, idle control valve among other things- he is getting fuel pressure and replaced my faulty driver side lock module. he is getting NO codes on it at all and has finally checked my ECU...
  14. R

    You mean to tell me...

    thanks joey- its an '01-- while i've got you here, have you heard of any problems stemming from putting in your own trailer lighting rig? I got the universal part from wal-mart and am set to go...just thought i'd get your opinion. thanks as always!
  15. R

    You mean to tell me...

    ...that I could've had heated seat ALL ALONG!?!?! So I got an email from Atlantic British about their conversion kit and was thrilled. I went down to my local parts guy (Rover Land) in Tampa, FL and collected the 2 switches and cover plate...for basically pennies! Now my wife is LOVING the...

Latest posts

Members online

No members online now.

Forum statistics

Threads
36,720
Posts
222,759
Members
30,894
Latest member
PanKyiv
Top