-
-
djkaosone replied to the thread Throttle body coolant line mystery.The pipe runs to the rear crossover pipe that connects to both heads. Which helps fill the block from the rear and gets just enough... -
Hey All!! Well, it's been a hot minute, but I finally got all the "to-do" list taken care of at my mom's place, and FINALLY had a few...
-
djkaosone reacted to Pfunk951's post in the thread Write up: High Pressure Fuel Pump (HPFP) Replacement with
Like.
Pump removal I’m not going to lie- it’s going to get tight here. We’ve got a frame rail right in the way, but plenty of room in front... -
djkaosone replied to the thread stainless steel brake lines.The rear comes in a kit with both inner/outer ss lines and hardware, full replacement to all rubber lines. The front is single ss line...
-
Removed rear seats And added 80L of water, drawer, fridge etc
-
djkaosone replied to the thread stainless steel brake lines.I've had mine on since my brake conversion to fit 17s since 2017 and the SS brake lines have been good to me. BTW, here are the part...
-
djkaosone replied to the thread Head Removal.It's a good amount of work to get the heads off and put everything back together. I've removed the heads with the body on with an engine...
-
djkaosone reacted to San Moritz LR4's post in the thread Has anyone run the Rubicon Trail in an LR3 or LR4? with Like.
UPDATE -- I am getting a new rear bumper installed by Tactical 4x4, including all the bells and whistles...side step, tire carrier...
-
djkaosone replied to the thread Third head gasket job- why are they failing?.Good point @greiswig. Here's a dumb question... going with oem head gaskets again for my '11 LR4. Do I get the original superseded...
-
djkaosone replied to the thread System too lean at idle - Bank 1 and 2.Have you tried replacing both MAFs? The MAFs will affect fuel trims. What are the STFT and LTFT on both banks?
-
djkaosone replied to the thread Third head gasket job- why are they failing?.@Red Top Engine How's it holding up with the copper spray coat? My replacement head gasket is toast right around 2 years too and was...
-
djkaosone replied to the thread Colorado Land Rover Owners: Is British 4x4 in Aurora still in business? I can't seem to get in touch with them.I second this! A family friend services both of his LR4s there. They have a working LR4 LS conversion kit in the works too!
-
djkaosone reacted to CRYA's post in the thread Colorado Land Rover Owners: Is British 4x4 in Aurora still in business? I can't seem to get in touch with them with Like.
Roadside Werx FTW!
-
-
Loading…
-
Loading…
