Search results

  1. M

    Rear parking sensor system failure

    Hi, So the rear parking sensor system on my 2010 has totally failed. Put it in reverse and the parking sensor dash button flashes several times and then goes out. No beeping from sensors at back (or front). Over past 24 months have replaced all four sensors at the back with non-OEM parts. When...
  2. M

    Starting issue

    Week later and negative deg. C Temps and no reoccurrance of problem after fitting new battery....... fingers crossed :)
  3. M

    Starting issue

    Yes, good point. New battery it is!
  4. M

    Starting issue

    Yes, 12V at battery terminals with engine turned off..............okay........ that saves me $400!
  5. M

    Starting issue

    So this morning with overnight temps of 5degC the voltage at the battery terminals was 12V off, 10.6V cranking. Car started fine. Thinking may be the starter motor. Confirmed the battery is 4yo.
  6. M

    Starting issue

    V. Meter: Off 12.6V Running 14.7V Cranking 11.2V Iid tool Off 12.5V Running 14.5V Cranking 11.2V So near identical results. Will try again tomorrow morning from cold
  7. M

    Starting issue

    I just topped up transmission fluid with 1L a week ago.......I need to recalibrate the transfer case??
  8. M

    Starting issue

    Engine running 14.2V Engine off 12.5V During cranking - did a few times and voltage varied between 9.2V and 11.5V Battery toast?
  9. M

    Starting issue

    Think it did go stiff after a couple of presses, but then no power steering with engine off, so probably normal?
  10. M

    Starting issue

    Not sure about brake pedal. Did you fix it?
  11. M

    Starting issue

    Oh I can check voltage using my gap ID tool!!
  12. M

    Starting issue

    Yes, after car parked overnight. Just back from 1,000 mile road trip with no issues. What would healthy voltage at battery terminals be during cranking?
  13. M

    Starting issue

    My research suggests starter solenoid starting to fail, so a new starter is needed. No issue with battery not charging (I.e. battery or alternator issue). Sound about right?
  14. M

    Starting issue

    Hi, 2010 V8 105k miles. A couple of times over the past 6 months you go to start it and there's a click and nothing else. Repeat starting a few times and all okay. Has now happened several times over past 24hrs. This morning also turned over for a fraction of a second, before faltering and then...
  15. M

    Workshop service manual for north american 2010 LR4 V8

    Thanks! Just replied.
  16. M

    Workshop service manual for north american 2010 LR4 V8

    Hi, I have bought two $20 download manuals online and both have various issues (missing figures, poor formatting etc.). Can anyone kindly recommend a reliable source for the full LR workshop manual?
  17. M

    Air compressor hose disconnection????

    Panic over. Got them off!
  18. M

    Air compressor hose disconnection????

    So.........trying to take out the Hitachi compressor on my 2010. I cannot get the two air lines equipped with metal quick connect fittings to release at the rear of the unit? Squirted with WD40, tried placing an open ended wrench head and pressing it against the quick release while pulling on...
  19. M

    LR bolt specs?

    Not sure a screw extractor would work as bolt head snapped off. It may loosen as I drill it out.
  20. M

    LR bolt specs?

    Well I am hoping the other three bolt shafts are larger dia as they are holding the weight of the compressor. The single bolt on the underside of the plastic case is not holding much weight. It snapped immediately without much torque. I sprayed the other three bolts holding the bracket with...
  21. M

    LR bolt specs?

    Yes, obvs metric is metric. Its the thread pitch that I guess puzzles me. As an example, I wanted to clean up the threads on the half shafts. Bought a "shark tooth" gauge to determine the thread pitch, but was not very definitive re. Determining what die size to buy.
  22. M

    LR bolt specs?

    Hi, Bolt size specs have always been a mystery to me. I am in Canada so we have north American sizing systems and also metric. LR bolts take metric spanners so obvs metric sized bolts, but is there more than one metric system? I ask because the lower air compressor bolt that holds the plastic...
  23. M

    Transmission oil leak........

    Well that was a doddle! Kept an eye on temp using a BBQ thermometer on the outside of the pan. No risk of cat burns using a socket extension. Added a litter, of which 500ml or so probably leaked when I messed with it yesterday. Did not have new filler plug, but have booked it into get the leak...
  24. M

    Correct procedure for checking transmission fluid level on 2010 LR4 URGENT! :(

    So I presume the torque for the plug is 35Nm. Only need to do the calculation if I am using a torque wrench attached to the end of the special tool?
  25. M

    Correct procedure for checking transmission fluid level on 2010 LR4 URGENT! :(

    Ahhhh..... I do but its a bootleg version. When I checked it, it had the pictures but not the text........thanks!!

Latest posts

Members online

No members online now.
Total: 1,372 (members: 0, guests: 1,372)

Forum statistics

Threads
37,146
Posts
226,329
Members
31,263
Latest member
KyleK951

Share this page

Top