Search results
-
Prepping for SCV6 120k mi service
Quick update on this project as I'm about 80% done: -I decided to go with the official JLR metal pipes mainly due to seeing varying results with the aftermarket o-rings; better QC and piece of mind for me -I also decided not to attempt the walnut blasting; once everything was apart there still...- 16FujiDisco
- Post #21
- Forum: LR4
-
Paint Cost
Is the clear toast all over? If it were in the middle you could cover it with one of the black decals. Maybe wrap it to match instead?- 16FujiDisco
- Post #2
- Forum: LR4
-
Valvoline Restore & Protect?
Same for me. I also replaced the standard plug with a fomoto valve so it’s mess free- 16FujiDisco
- Post #18
- Forum: LR4
-
Lube Guard Instant Shudder fix - works….RPM fluctuation and trans shudder gone
@Al Pizzica im not saying you’re wrong, but that kind of amazes me; the ZF Lifeguard fluid is thinner and ‘slippery-er’ than any other trans fluid I’ve seen before, especially Mercon.- 16FujiDisco
- Post #21
- Forum: LR4
-
A Pillar Foam Part Number
Thread 'Foam block at the hood corners near A pillar' https://www.landroverworld.org/threads/foam-block-at-the-hood-corners-near-a-pillar.42583/- 16FujiDisco
- Post #3
- Forum: LR4
-
Passenger rear door rattle
Team, I’ve got an annoying rattle that comes and goes from the rear passenger door trim at the spot where the red arrow points. Anybody else have this issue before? Does anybody know how this attaches? Clips or double sided tape? It doesn’t feel loose and it doesn’t do it all the time. I...- 16FujiDisco
- Thread
- Replies: 1
- Forum: LR4
-
Entire bank 2 misfire
Cam position sensor on that side going out? Or the cam solenoids? Getting better with each restart sounds like the system is getting more/better data, then running as should be. I would think that chain stretch would be a more consistent issue- 16FujiDisco
- Post #5
- Forum: LR4
-
Crazy I know but any 19" wheel suggestions?
Have the chance to get a set (5) of 19” Defender 6010 wheels for a great deal with 255/65/19 Goodyear Wrangler ATs; should I grab them or pass? I know the spare won’t fit now, but I could always go down to a 255/55 next set of tires to get back to stock equivalent- 16FujiDisco
- Post #17
- Forum: LR4
-
SC V6 Overheat Spike at Highway Speeds
Any restricted performance warnings? Maybe a bad SC water pump?- 16FujiDisco
- Post #3
- Forum: LR4
-
Prepping for SCV6 120k mi service
Figured I'd do all the pulleys and tensioners while I'm in there; looking for a P# for Green #1, and Red #2 if anyone can help: Green: 1 - ? - tensioner - can this be bought separate? 2 - LR039516 - idler 3 - LR011325 - fan pulley Bracket w/ 1&2 - LR079294 Red: 1 - LR106769 - idler 2 - ? -...- 16FujiDisco
- Post #20
- Forum: LR4
-
Air Conditioner Help
Yes, different connectors than 134a; I haven’t seen the new freon in stores anywhere, seems to be only available online (and it’s pricey)- 16FujiDisco
- Post #4
- Forum: LR4
-
Lost all key fobs - 2015 LR4
I could also see someone wanting proof of ownership to do this- 16FujiDisco
- Post #3
- Forum: LR4
-
Battery life
This is my routine as well. We have 3 cats but now both work from home, so we’d have dead batteries everywhere if I didn’t tender them.- 16FujiDisco
- Post #34
- Forum: LR4
-
Prepping for SCV6 120k mi service
@q5sys this is consistent to what I’ve found as well; jag forums have more discussion and P#s- 16FujiDisco
- Post #18
- Forum: LR4
-
Prepping for SCV6 120k mi service
Just did a re-build <5k ago; that was the only source of oil seepage I saw down there. Are we doing VCGs preventatively? Passenger side was done ~50k ago, but no signs of repeat failure, or driver side leakage.- 16FujiDisco
- Post #12
- Forum: LR4
-
Prepping for SCV6 120k mi service
@scapistron no signs of the mounts being bad currently. LCAs and bushings were done @ 77k mi., and I haven’t felt and systems of them going out again; just had an alignment (every 5k) and it was still within spec from the last. Tech did say my rear passenger tie rod was seized “inner to outer”...- 16FujiDisco
- Post #9
- Forum: LR4
-
Has anyone reflashed their 3.0SC V6 aka Tune?
@scapistron the 2300 is only available as an upgrade to the V8 SC at the moment- 16FujiDisco
- Post #186
- Forum: LR4
-
Prepping for SCV6 120k mi service
Yea, that’s what I’m torn about. If it’s just going to be a 50k mi service item, I’m fine with that. I’m also thinking the o-rings on the metal pipes are not permanent fixes, so they’ll still need servicing at some point; we just don’t know that mileage yet. Maybe they wait until the 170k-ish...- 16FujiDisco
- Post #6
- Forum: LR4
-
Prepping for SCV6 120k mi service
@Longtrail I’m still up in the air on switching to the upgraded metal parts for everything; I haven’t seen a lot of feedback on here for those that have converted. I probably need to scan the jag forums to get more results and see which brand is more popular (I think there are a few now) Chains...- 16FujiDisco
- Post #4
- Forum: LR4
-
Prepping for SCV6 120k mi service
Alright folks, looking to gather some intel, thoughts, suggestions about what I’m planning in the 120k mi range. As of now I’m at 112k, but the next time I have everything apart I want to touch as much as needed. I’m thinking of: -crossovers (front & rear), water pump, thermostat, pcv valve-...- 16FujiDisco
- Thread
- Replies: 25
- Forum: LR4
-
Has anyone reflashed their 3.0SC V6 aka Tune?
Has anyone had their supercharger ported? From what I can gather it’s about 30-50 hp gain and 40ish ft/lb. VAP is now offering it, and there are a couple other companies as well (Kong performance, JorkerZ); they seem to be pretty competitive in price with each other. I picked up a used...- 16FujiDisco
- Post #183
- Forum: LR4
-
Best way to clean out sunroof drains
I’ve tried to check mine but I can’t for the life of me find the holes to feed line through- 16FujiDisco
- Post #9
- Forum: LR4
-
Sudden Hissing near Valve Cover (5.0 V8)
Brake pedal click - mine does this as well, and it’s been doing it for as long as I can remember now; no issues. Like you I noticed it one day and now I can’t ‘un-hear’ it. I assumed it always made that noise and I just didn’t notice it…until I did. Doesn’t bother me, and there are plenty of...- 16FujiDisco
- Post #4
- Forum: LR4
-
2016 LR4 Landmark with bi-colored hood
This also has the ‘black design package’ which is another option on top of the Landmark- 16FujiDisco
- Post #13
- Forum: LR4
-
Valve Cover Gasket / Front Timing Cover Questions
It absolutely will work; I just did this job on mine and it fixed my leak from the cover. I used the kit from RKXTech and replaced all seals- 16FujiDisco
- Post #9
- Forum: LR4
