Search results
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
Don't just go replacing parts because of a DTC. That oil pump requires complete engine disassembly. I have yet to see one of those oil pumps fail.- Rover Range
- Post #4
- Forum: LR4
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
a) Autel probably giving incorrect DTC. b) The solenoid is integrated with the oil pump. The solenoid opens a passage at low rpms to reduce oil pressure. Which is intended to reduce fuel consumption.- Rover Range
- Post #2
- Forum: LR4
-
C1130-66 Air Spring Supply
C1130-66 indicates that the suspension is in tight tolerance mode. Used when doing alignments. The other two are "ghost codes." I would disconnect the battery for 15min, reconnect and see what happens.- Rover Range
- Post #2
- Forum: LR4
-
Break in the MOST ring? Fiber optic interconnect
Land Rover dealerships have a repair kit for the fiber optic cables. Basically inserting a male and female connector where the break is.- Rover Range
- Post #9
- Forum: LR4
-
2011 LR4 Suspension code U3000-1D
What is your VIN #? I can look up the DTC and let you know the next step.- Rover Range
- Post #6
- Forum: LR4
-
2010 LR4 Air suspension need advice
White residue will be in the air lines.- Rover Range
- Post #26
- Forum: LR4
-
Smart Key low battery on Clusterboard still shows warning, even though I have changed the battery on the FOB. Any suggestions?
Sometimes , with the engine running, you can push the unlock button on the fob two times.- Rover Range
- Post #2
- Forum: Range Rover
-
Transmission Heat Shield
TSB for the LR4 is, LTB01207 Renew bracket and install foam pads as shown.- Rover Range
- Post #12
- Forum: LR4
-
Tailgate open error
Could be a bad pin switch in the upper tailgate latch.- Rover Range
- Post #2
- Forum: LR4
-
LR4 Window problems
With the engine running. Windows closed. Lift up on the window switch, hold for 5 seconds and release. Repeat once.- Rover Range
- Post #6
- Forum: LR4
-
Rangerover l322 suspension fault
You have an air leak somewhere.- Rover Range
- Post #2
- Forum: Range Rover
-
Control arms debacle
Believe it or not. I've see it before. The arms were swapped and upside down. The arms should slip right into the frame mounts when installing.- Rover Range
- Post #4
- Forum: LR4
-
-
Anyone swapped out for newer seats?
At a quick glance, the seat frame mounts look the same.- Rover Range
- Post #3
- Forum: LR4
-
LUX vs Vision package
Send me your VIN # and I get you the official Land Rover build list.- Rover Range
- Post #8
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
2013 on up models have the revised chain guides.- Rover Range
- Post #17
- Forum: LR4
-
Fuel pressure regulation
The timing marks on the fuel pump drive sprocket has to line up with the colored link on the chain. Did you use the timing tool at the vacuum pump?- Rover Range
- Post #6
- Forum: Range Rover
-
Milling....
Any decent machine shop will know the maximum that they can machine off the head gasket surfaces without causing issues. Land Rover doesn't recommend machining the block and heads, that you would need thicker head gaskets. The cylinder liners are Nikasil. If that liner is machined, the Nikasil...- Rover Range
- Post #5
- Forum: LR4
-
Milling....
The cylinder liners can't be bored. Unless the liners are re Nikasiled. 1) Land Rover says maximum allowed warpage is 0.008in. They don't offer thicker head gaskets. 2) Yes.- Rover Range
- Post #2
- Forum: LR4
-
P0016 comes and goes after oil change
Could be an issue with the VVT sprockets.- Rover Range
- Post #4
- Forum: LR4
-
P0016 comes and goes after oil change
That DTC indicates that the cam timing is off.- Rover Range
- Post #2
- Forum: LR4
-
Fuel pressure regulation
It involves locking the flywheel , removing the vacuum pump and installing an alignment tool into the vacuum pump drive.- Rover Range
- Post #4
- Forum: Range Rover
-
Fuel pressure regulation
Sounds like the high pressure fuel pumps are out of time. Chain for the balance shaft may have jumped time. Balance shaft operates the pumps.- Rover Range
- Post #2
- Forum: Range Rover
-
Difficulties finding steering shaft parts! If you have access to OEM catalogs, help!
LR071147 Is the correct part from Land Rover.- Rover Range
- Post #2
- Forum: LR4
-
