Search results
-
LR4 Air Suspension Fault - Inflating too fast?
Replace the air suspension compressor.- Rover Range
- Post #4
- Forum: LR4
-
Help in identifying part - Timing Chain Service
8 to 10Nm is about right. I think the plastic is just brittle.- Rover Range
- Post #10
- Forum: LR4
-
Help in identifying part - Timing Chain Service
As a last resort. You can put a flat washer on the bolt. Also use Loctite on the bolt.- Rover Range
- Post #6
- Forum: LR4
-
Help in identifying part - Timing Chain Service
I looked at a couple engines here. Both have a steel ball in that port. The hunt continues....- Rover Range
- Post #4
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
If you heard the loud pop when you pulled the pin, you're golden.- Rover Range
- Post #14
- Forum: LR4
-
Help in identifying part - Timing Chain Service
Looks like an oil passage plug. I would replace it. Probably not available from Land Rover. We have some used engines here at work. I can snag you one.- Rover Range
- Post #2
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
I think that's if you're reusing the old tensioner. Which no one does.- Rover Range
- Post #12
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
You absolutely don't pull the pin, until everything is assembled.- Rover Range
- Post #10
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
There's no oil in the tensioner, from the factory. The internal spring mechanism is locked and loaded, until you pull the pin.- Rover Range
- Post #6
- Forum: LR4
-
That's all Folks! 15 years of Rover ownership has come to end.
Double post- Rover Range
- Post #15
- Forum: LR4
-
That's all Folks! 15 years of Rover ownership has come to end.
I've ridden several times with Guy Perrett and Marty Halmanza. (When they came down to Texas) Obviously, not at their level. :oops:- Rover Range
- Post #14
- Forum: LR4
-
V8 5.0L Intake Manifold - what is the rear sensor?
Not a sensor. It's a vacuum solenoid that controls the intake diverter flaps.- Rover Range
- Post #3
- Forum: LR4
-
-
-
That's all Folks! 15 years of Rover ownership has come to end.
Nice. I need to take a road trip!!- Rover Range
- Post #12
- Forum: LR4
-
New 2025 RR SE SWB P530 - sound system question
I've never heard of an upgraded amplifier added after the sale. When there was a chip shortage, a few options were deleted. But, you couldn't -easily- go back and add it in.- Rover Range
- Post #2
- Forum: Range Rover
-
Looking to purchase timing chain tools
Unless the locking tool is not machined properly, will only fit one way. There's only one "big" hole in the flywheel. The VVT sprocket bolts should be loose when you pull the grenade pin on the tensioners.- Rover Range
- Post #65
- Forum: LR4
-
Looking to purchase timing chain tools
Crank tool that fits where the crank sensor is, will only fit one way.- Rover Range
- Post #60
- Forum: LR4
-
That's all Folks! 15 years of Rover ownership has come to end.
Good to see fellow riders on here. Here's my set up.- Rover Range
- Post #10
- Forum: LR4
-
2013 RR L405 5.0SC - No interior heat
There's a hot water valve that can get stuck closed. It's located right under the hood, behind the right front strut.- Rover Range
- Post #2
- Forum: Range Rover
-
-
Looking to purchase timing chain tools
Crank is 180 out. Keyway should be in the 12 o'clock position.- Rover Range
- Post #56
- Forum: LR4
-
Looking to purchase timing chain tools
Did you remove the pulley - part that the belt rides on? The puller will use the pulley mounting bolt holes.- Rover Range
- Post #53
- Forum: LR4
-
Radio and all sounds stopped
Standard operating procedure: hard reset.- Rover Range
- Post #3
- Forum: Discovery 5
-
That's all Folks! 15 years of Rover ownership has come to end.
What vehicle replaced the LR4?- Rover Range
- Post #3
- Forum: LR4
