Search results
-
Open to Suggestions
Did you install the wiring harness on the engine, before installing the engine?- Rover Range
- Post #78
- Forum: LR4
-
Open to Suggestions
Sweet. Good thing you didn't try to use the bell housing bolts to "suck it together ".- Rover Range
- Post #75
- Forum: LR4
-
Open to Suggestions
Sorry. I was thinking of a different year model. Either way, installation of the converter would be the same. The torque converter sits like the pic shows. Make sure the flywheel is not on backwards.- Rover Range
- Post #73
- Forum: LR4
-
Open to Suggestions
Pull the converter out. Line up the notches in the converter with the two lugs in the transmission. While supporting the converter as level as possible. Insert into transmission while gently rotating a couple degrees. You will hear a solid clunk when the converter seats into the pump.- Rover Range
- Post #70
- Forum: LR4
-
Open to Suggestions
Torque convertor needs to be further back. Take a screwdriver and turn the torque convertor, through that hole. Hopefully the torque convertor will pop into the the transmission front pump.- Rover Range
- Post #68
- Forum: LR4
-
Open to Suggestions
Torque converter is not fully seated in the transmission.- Rover Range
- Post #65
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
You will have to pay for the repair and submit for reimbursement through your local dealer.- Rover Range
- Post #26
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
There's one on the fuel pump, which comes on the new pump. The other is on a rail that extends to the front of the tank. It is 100% accessible when the pump is removed. That's how you replace it.- Rover Range
- Post #16
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
Who are these clowns? The sender is right there when you remove the pump. It can be a pain. But, it just slides out of the guides and the new one slides back in.- Rover Range
- Post #14
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
SROs is the labor operation for booking the repair.- Rover Range
- Post #13
- Forum: LR4
-
How to replace LR3 front driver's seat cover
Best to have an upholstery shop do it. They have the steamers etc to ensure a nice snug fit.- Rover Range
- Post #2
- Forum: LR3
-
Fuel Outlet Flange Recall and Other Services
They can't be serious. Parts required for the recall. Fuel tank flange assembly LR112785 1 Fuel filter LR175172 1 Bracket LR113338 1 Fuel tank flange O-ring LR117476 1 Hose clip CN1005 New fuel filter:- Rover Range
- Post #5
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
If you're doing the fuel pump, replace the fuel senders too.- Rover Range
- Post #3
- Forum: LR4
-
Fuel Outlet Flange Recall and Other Services
A new fuel filter is part of the recall!- Rover Range
- Post #2
- Forum: LR4
-
Water leaking just started yesterday, HELP
Check the sun roof drains in the passenger foot well.- Rover Range
- Post #2
- Forum: LR4
-
Transmission “Free Wheeling”
I would disconnect the battery for 15 minutes. That will clear the transmission learned adaptations. See if that helps.- Rover Range
- Post #2
- Forum: LR4
-
Discovery 4 sdv6 GS Dreaded suspension fault help needed
What DTCs do you have? Throwing parts at it will cost you way more than a proper diagnosis.- Rover Range
- Post #2
- Forum: Discovery
-
2020 Range Rover Sport Hse - Crank but no Start, after accident , fuel pump not working
The restraints module (SRS) has locked out the fuel pump. The module will need to be replaced with a new one and reflashed .- Rover Range
- Post #2
- Forum: Range Rover
-
-
Water Pump & Outlet Pipes Replacement
Supercharger doesn't have to be removed to replace the front crossover pipes.- Rover Range
- Post #7
- Forum: LR4
-
Open to Suggestions
Better hope the new sensors are good. :rolleyes:- Rover Range
- Post #48
- Forum: LR4
-
Passing Wires from the Engine Bay through the Firewall to the Cabin
Follow the hood release cable where it goes through the firewall. Use that grommet to route your wires.- Rover Range
- Post #2
- Forum: Range Rover
-
Zip kit and fluid change, now won't go past 5th
Either low on fluid or the shuttle valve at the manual linkage not in the proper position.- Rover Range
- Post #5
- Forum: LR4
-
Open to Suggestions
Some vehicles have a symposer. Which is attached to that fitting. The vehicles that don't have it, the port is capped off. The symposer creates a V8 like sound on acceleration.- Rover Range
- Post #32
- Forum: LR4
-
Mysterious Rear Thump Clump
Have the dealership diagnose it. I'm sure they have heard the noise before. Guessing can get expensive.- Rover Range
- Post #4
- Forum: Discovery 5
