You just possibly saved my life!, I started this job removing the SC 2 days and was at a loss when I couldn't get the SC up and out, so I put it all back together. I want to try again in hopes to get to the isolator changed out. Thanks for posting the PDFs.
2003 Disco II 4.6L with 99600 miles (just saying)
Hey was looking to change out my oil pan gasket, my grandpa is a retired mechanic so hes gonna give me a hand replacing some of my bad gaskets. I have been researching and have seen alot of people say you have to lift out the engine a bit in...
After reading into it more and such I agree its not o2 sensors, im working and moving today and the remainder of the week so dont have much time to work on it :( . Was debating on taking it to a professional to have it checked.
2003 Discovery Series II 97k
Got into my truck this morning to go to work and when I turned it on it started shaking intensely and the engine light started flashing.(have not checked any codes or anything, havent been home) Yesterday had put cross member spacers on (Recently replaced front...
Yesterday I installed a new drive shaft, and the spacers for the cross member. Today i turned on the rover and it started shaking and the engine light was flashing, I'm on my way to work (not driving) so i don't have a chance to further look into it. Any where i should start looking? Spark...
Valve Cover gaskets ordered, having a friend help me with the job, also ordered a transmission filter kit, all new u joints and ball joint for front drive shaft, and also have cross member spacers ordered. Cant wait to get this all done. Next up ordering a new top to the air intake box...
So the head gasket seal, valve cover gasket and intake gaskets need to be changed. also the air box cover needs to be changed because all of the clips are broken. Parts have been ordered for the front prop shaft.
New issue, knocking coming from the mid right side of the motor. Place i took it to wouldnt even look at the truck until it was fixed. What are some common issues in the 4.6L that create the knocking that I should look into first? Should I seek professional help immediately or is there something...
While I order the parts for the Front prop shaft should I rebuild the rear as well? Also any advice or alternatives for the cross member issue with the lift? I will try to post up some photos tomorrow of the rover.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.