Recent content by Jleebee1975

  1. J

    Determined Disco Driver

    Thanks mike I will look into getting one today. After reading another thread I am assuming that the sensor is located on the driver side bell housing and has a little heat shield with 2 boltsh holding it in place...is this correct?
  2. J

    Determined Disco Driver

    00 L/R Disco 2. Let me first say that I love this truck but lately I have been contemplating selling it. I am fairly mechanically inclined but dont have the foggiest idea where the crankshaft position sensor is located or a notion as to what it looks like. The truck started cutting off...
  3. J

    Crankshaft position sensor code

    Now I am also getting code P1884 Mass air flow circuit low, but this is a first for that one and it doesnt duplicate when reset. The truck will start most of the time but after it runs for about a minute or so it will act as if its going to cut off and then it will come right back on. That is...
  4. J

    Where is the ECM located?

    Can anyone tell me where the ECM is located on a 2000 Land Rover Discovery 2? I am still having the problem with the crankshaft position sensor code. A few months back the dealership replaced the ECM in my truck and im wondering if maybe the wiring harness was damaged or if the connectors are...
  5. J

    Crankshaft position sensor code

    Mike thanks for responding. I only get one code and it is P0335. Sometimes the check engine light even resets itself and then when it trips again its still P0335.
  6. J

    Crankshaft position sensor code

    Joey, do you have any ideas? Can anyone tell me where I should start looking?
  7. J

    Crankshaft position sensor code

    I have a 2000 LR disco 2. Recently it started cutting off while driving and coming back on wth the drive, manual, and sport lights flashing and won't shift out of whatever gear its in when it does it until I turn the engine off and restart it. Now the engine will cut off sporadically while...
  8. J

    Parts on hand?

    2000 LR disco 2...Can anyone tell me what replacement parts I will have to have on hand for pulling a valve cover to check rocker arms and lifters. I just want to make sure I have any gaskets or replacement parts I may need for this job on hand in case I have to order them prior. Thanks for...
  9. J

    High mileage?

    thanks Thanks for all of the good info guys.
  10. J

    Ticking Noise Continued

    ticking noise Will I need to have any replacement gaskets on hand to reassemble? Hoping I just need to tighten a rocker arm and then can put it back together. I just want to make sure I dont have to wait for any gaskets and can have them on hand if I need them for reassembly.
  11. J

    Ticking Noise Continued

    it continues The lucas was a very temporary band-aid. By the time I got home the ticking was back...not as prominent but back none the less. Im confident I can pull the valve cover...its the intake with all of its hoses and cables that bother me. Is there a way to pull the cover without...
  12. J

    Ticking Noise Continued

    Joey, I went with the assumption that it was a chattering lifter or rocker. My oil level was about half a quart low so I replaced it with some lucas oil additive and the noise went away almost immediately. Forgive my ingorance but do you perceive this to be a good fix or should I...
  13. J

    Ticking Noise Continued

    I will try that. It doesnt look simple though. Im guessing I have to pull the intake as well to reach the inner bolts of the valve cover?
  14. J

    Ticking Noise Continued

    The ticking noise coming from the passenger side of the engine in my 2000 LR disco 2 is becoming more prominent. Again, this never happens on start up, only after driving. I now noticed that the sound is coming from under the passenger side valve cover and it is still there even when I...
  15. J

    Ticking Noise

    any more ideas? the sound is really loud under the passenger side valve cover...but its not consistent. Sometimes it is quiet and smooth and others like a hammer is pounding the valve cover.
See more

Latest posts

Members online

No members online now.
Total: 344 (members: 1, guests: 343)

Forum statistics

Threads
36,272
Posts
218,137
Members
30,499
Latest member
Vintage99

Share this page

Top