Search results

  1. J

    Determined Disco Driver

    Thanks mike I will look into getting one today. After reading another thread I am assuming that the sensor is located on the driver side bell housing and has a little heat shield with 2 boltsh holding it in place...is this correct?
  2. J

    Determined Disco Driver

    00 L/R Disco 2. Let me first say that I love this truck but lately I have been contemplating selling it. I am fairly mechanically inclined but dont have the foggiest idea where the crankshaft position sensor is located or a notion as to what it looks like. The truck started cutting off...
  3. J

    Crankshaft position sensor code

    Now I am also getting code P1884 Mass air flow circuit low, but this is a first for that one and it doesnt duplicate when reset. The truck will start most of the time but after it runs for about a minute or so it will act as if its going to cut off and then it will come right back on. That is...
  4. J

    Where is the ECM located?

    Can anyone tell me where the ECM is located on a 2000 Land Rover Discovery 2? I am still having the problem with the crankshaft position sensor code. A few months back the dealership replaced the ECM in my truck and im wondering if maybe the wiring harness was damaged or if the connectors are...
  5. J

    Crankshaft position sensor code

    Mike thanks for responding. I only get one code and it is P0335. Sometimes the check engine light even resets itself and then when it trips again its still P0335.
  6. J

    Crankshaft position sensor code

    Joey, do you have any ideas? Can anyone tell me where I should start looking?
  7. J

    Crankshaft position sensor code

    I have a 2000 LR disco 2. Recently it started cutting off while driving and coming back on wth the drive, manual, and sport lights flashing and won't shift out of whatever gear its in when it does it until I turn the engine off and restart it. Now the engine will cut off sporadically while...
  8. J

    Parts on hand?

    2000 LR disco 2...Can anyone tell me what replacement parts I will have to have on hand for pulling a valve cover to check rocker arms and lifters. I just want to make sure I have any gaskets or replacement parts I may need for this job on hand in case I have to order them prior. Thanks for...
  9. J

    High mileage?

    thanks Thanks for all of the good info guys.
  10. J

    Ticking Noise Continued

    ticking noise Will I need to have any replacement gaskets on hand to reassemble? Hoping I just need to tighten a rocker arm and then can put it back together. I just want to make sure I dont have to wait for any gaskets and can have them on hand if I need them for reassembly.
  11. J

    Ticking Noise Continued

    it continues The lucas was a very temporary band-aid. By the time I got home the ticking was back...not as prominent but back none the less. Im confident I can pull the valve cover...its the intake with all of its hoses and cables that bother me. Is there a way to pull the cover without...
  12. J

    Ticking Noise Continued

    Joey, I went with the assumption that it was a chattering lifter or rocker. My oil level was about half a quart low so I replaced it with some lucas oil additive and the noise went away almost immediately. Forgive my ingorance but do you perceive this to be a good fix or should I...
  13. J

    Ticking Noise Continued

    I will try that. It doesnt look simple though. Im guessing I have to pull the intake as well to reach the inner bolts of the valve cover?
  14. J

    Ticking Noise Continued

    The ticking noise coming from the passenger side of the engine in my 2000 LR disco 2 is becoming more prominent. Again, this never happens on start up, only after driving. I now noticed that the sound is coming from under the passenger side valve cover and it is still there even when I...
  15. J

    Ticking Noise

    any more ideas? the sound is really loud under the passenger side valve cover...but its not consistent. Sometimes it is quiet and smooth and others like a hammer is pounding the valve cover.
  16. J

    Ticking Noise

    After listening to this more carefully, I found the noise is actually coming from the passenger side of the engine. If sounds as if someone is tapping on the valve cover with a hammer. It never happens at startup only after I have been driving and then stop, and again it doesnt happen all of...
  17. J

    High mileage?

    My 2000 LR disco 2 has 119,000 miles on it. It has had both head gaskets replaced, valve cover gaskets, intake gaskets etc. My truck runs and drives great with the only leak being a small one at the rear of the oil pan. Other than the ticking noise that developed it seems strong. What is...
  18. J

    Ticking Noise

    Im guessing that neither are cheap fixes....especially if the sleeve is loose. Im assuming you are talking about the sleeve in the cylinder wall around the piston. Sounds like this can cause major damage. How can I tell which one it is exactly and what damage can be incurred if left...
  19. J

    Ticking Noise

    I have 2000 Disco 2 with 119,000 mile on it. It runs and drives beautifully however I recently noticed a loud ticking noise coming from the driver side of the engine while at an idle. It doesnt do this all of the time, just every now and then and it goes away when I accelerate. I would...
  20. J

    Electrical Issues?!?!

    Thanks for all of the good advice. I will be checking everything this afternoon. I couldnt find any signs of leaks anywhere in my intake and all o rings are in place. Joey, I think your right about the power mirror switch because I found now at times it works in all positions I think I have...
  21. J

    00 Disco 2 headlight swap

    Thanks for the info, I went to discoweb.com and got a spanish music website. Is there a more specific URL?
  22. J

    Electrical Issues?!?!

    No new symptoms, the CEL just lights. As long as the weather is dry the light will stay off. Its when the roads get real wet that it will come on. It generally comes on after I have been driving in the rain and shut off the engine and then as soon as I start it back up it will come on. As...
  23. J

    Electrical Issues?!?!

    I am pulling a p1172 code, it says air flow metering system malfunction.
  24. J

    00 Disco 2 headlight swap

    Can anyone tell me how hard it is to swap the headlights from a 00 LR disco 2, to the 03/04 style? I like the looks and had read an article about someone that did this and they said it took 14 hours of work. The light assemblies look identicle in shape to me, im guessing there must me some...
  25. J

    Electrical Issues?!?!

    Does anyone have any ideas?

Latest posts

Members online

Total: 402 (members: 8, guests: 394)

Forum statistics

Threads
36,272
Posts
218,135
Members
30,499
Latest member
Vintage99

Share this page

Top