Search results

  1. ryanjl

    Ironman 4x4 Drawers

    My Ironman 4x4 drawers arrived today. These are the "900 mm" ones found here: https://ironman4x4america.com/storage-systems/locksafe-twin-drawers-900mm/ The "blue" edge is a protective film over a metal trim piece. Exterior dimensions are: Cabinet Length 35.43" (900mm) Cabinet Height...
  2. ryanjl

    Question about Suspension Faults and Blowing out the lines

    2012 LR4 currently sitting at 127,600 miles. I've been getting some suspension codes that have been popping up every few days. C112F-72 (AF) Air spring valve - Mechanical failure - actuator is stuck open ( on 26-07-2023 11:10:17 at 205367 km ) C1130-66 (AF) Air spring air supply - Algorithm...
  3. ryanjl

    Looking for a dog guard for an LR3/LR4. Part # VUB501170GEN

    Title says it all. Looking for a full size dog guard / cargo guard for a LR3 or LR4. The part number is VUB501170GEN.
  4. ryanjl

    10 - 13 LR4 Bi-Xenon Headlight Housings, Non Adaptive

    Have these up on eBay for buy it now or best offer. Left and Right bi-xenon headlight housings for the 10 to 13 LR4. Non-adaptive. Xenon bulb was replaced with a new Phillips bulb around 2 years ago. Driver's side: https://www.ebay.com/itm/294089018357 Passenger's side...
  5. ryanjl

    Steering shaft replacement

    Has anyone replaced the steering shaft on their LR4? I've had some symptoms off and on for the last year or so that are consistent with a binding u-joint in the steering shaft. I believe I access it by removing the heat shields inside the drivers' front wheel well?
  6. ryanjl

    A/C Blower Issue

    2012 LR4, around 96,000 miles. Was driving yesterday with the A/C on full blast when the blower suddenly cut out. All the dash knobs and whatnot still work and light up normal, just no cold air blowing. It's never made any odd sounds like a bearing going out; this is the first issue it's had...
  7. ryanjl

    LR4 Halogen Headlight Housings with LED Signature lights

    I have the passenger and driver side halogen headlight housings with the LED signature lights. Work for a 2010 through 2013 LR4. They are both in relatively good condition. Not yellowed or cloudy, never in a wreck, etc. Driver side looks like it had a halogen bulb explode inside it at some...
  8. ryanjl

    Some suspension fault codes this morning

    After a standard 15-minute commute to work this morning, I went to lower my suspension to clear a part of the parking garage and was treated to a 'ding' and the yellow triangle. Looks like I'm getting the following codes: I cleared the codes, and they immediately returned. Searching turns up...
  9. ryanjl

    Is anyone aware in a change in tie rods somewhere along the line?

    I'm having my mechanic put on new inner and outer tie rods, both left and right, while he's doing my lower control arms. I ordered the kits from Atlantic British. Right: https://www.roverparts.com/Parts/LR010668 Left: https://www.roverparts.com/Parts/LR010667 According to my mechanic, the...
  10. ryanjl

    Suspension Fault - C1A18-64

    Got a new suspension fault today. Sometimes it goes away after a restart, other times it doesn't. IID Tool says it's C1A18-64. "Pressure increases too rapid when filling reservoir - Algorithm based failure - signal plausibility failure." A search on this and the LR3 subforum turned up no...
  11. ryanjl

    Anyone ever removed the rear license plate bracket?

    Couldn't find anything on a search. I have a license plate frame from my dealer that I decided to remove after it's gotten tattered and worn. Went to unscrew the license plate, and the screws took quite a bit of torque before they finally started spinning. Unfortunately, spin is all they did...
  12. ryanjl

    "Ping" sound from engine when cold

    Did a cold startup on my 2012 yesterday morning and heard a "ping" sound coming from somewhere near the top or front of the engine, repeating at around a 1-second cadence. It was about 15 degrees out. I let the engine idle and it gradually got quieter, then stopped when the engine warmed up...
  13. ryanjl

    Five 18" LR3 10-Spoke Wheels

    I have five 18" LR3 10-spoke wheels in okay condition. Some curb rash, but nothing major. Can be used on an LR3 (obviously) or on an LR4 with 1.25" wheel spacers. I am not sure about other models. I have never used them myself. I bought them for my LR4 but am going in a different direction...
  14. ryanjl

    Strange stereo issue

    2012 HSE. I believe it just has the base stereo. Nearing the end of a 3 hour drive tonight, during which the wife and I were listening to a podcast from my phone connected via cable to the stereo through the port under the armrest, the stereo suddenly stopped playing the podcast and made a...
  15. ryanjl

    Loose exterior A-Pillar trim

    Driving on a highway this weekend in 25-35 mph wind and rain. Heard a muffled "pop" near the windshield and then a low-toned wind whistle. Once I got to my destination I determined that the passenger side exterior A-pilar trim was a little loose, but no amount of force would pop it back in...
  16. ryanjl

    Corrosion on air strut tube

    Did my front brakes this morning and saw this corrosion on the passenger air strut tube. Driver side was fine. Will probably call the service department on Monday, but has anyone seen this before?
  17. ryanjl

    Requirements for Land Rover CPO

    I've got a Certified Pre-Owned LR4 I picked up in January. It's been fantastic so far, but I've begun to wonder what the requirements are for the CPO program. For example, am I able to do oil changes or brake jobs myself, or must I take it to a dealer? What about other required services?

Latest posts

Members online

Forum statistics

Threads
36,260
Posts
218,017
Members
30,496
Latest member
washburn72
Top