I am due to replace my upper and lower control arms on my LR3. I have read many posts about using the same generation rrs lower control arms but haven't found any posts about using the uppers. It looks like the rrs uses higher quality or at least stiffer upper arms. They are cast alloy instead...
Has anyone done the transmission update that solves the California stop issue on a rover with high miles? I am sitting at 180k and just picked up an iidtool. My transmission has been fine but I have had the the California clunk since I got it. The guys over at Gap diagnostics have the warning...
sorry to ghost everyone! I had a height sensor on its way out. I noticed a few days later while driving with the off road screen set on the nav one wheel moved up and down rapidly while on smooth road then I got another warning. I have since replaced that sensor and all is good again. I have...
No traction light. Amber suspension light and a message on the info screen. The ride height did not change for the rest of the drive. I have a iidtool on the way. I was more curious if the code would stay in long enough to scan it. If it clears quickly I can take it to an indi Rover shop near...
Quick question. Does the computer store suspension faults or are they cleared when you restart? I drove a mountain road a couple days ago much faster than I should have. After a few minutes I got the amber suspension fault warning light. The next time I drove the warning was gone and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.