Recent content by BendRover123
-
Anyone running Tuffant steel wheels yet?
I have the same tuffants. they are beastly, the reason i bought them was the load rating, steel just have higher load ratings i think those are ~4000lbs around so when your offroading or rock crawling and say the whole cars weight would be on one wheel it would still collapse. However thats an...- BendRover123
- Post #34
- Forum: LR4
-
Storage Mod
Fantastic you just gave me another job to do for the summer. That will be good tool parts and towing supply storage which is currenly jammed under my seat, glove compartment, mid console storage, and those rear side storage compartments. Strangely everything fits into those as well but ts a bit...- BendRover123
- Post #12
- Forum: LR3
-
"Unusual" preventive maintenance?
Another soft time item on the LR3 is actually the starter and alternator. While you never know when they fail, they will and that will basically leave you stranded anywhere. so my approach is: 1. ~150,000 replace alternator, starter, earlier if you been going through car batteries every 2...- BendRover123
- Post #8
- Forum: LR4
-
Storage Mod
Was thinking about doing the same! A few questions if you dont mind sharing: PNs on ebay examples? Was it hard to remove third row seat (any airbag connections etc) Once removed is there any cutting welding involved Are you running a full size spare or a donut spare? Does the LR4 also have...- BendRover123
- Post #10
- Forum: LR3
-
LR3 Seat Rock Fix
Which seat and what type of motion are you experiencing? Any pictures of the cable, cable attachment? This summer i was going to fix a sliding forward issue which is due to worn plastic washers in the rail forward and aft rotating cork screw. Probably not your issue.- BendRover123
- Post #2
- Forum: LR3
-
Ride Height Sensor Question
Regarding member https://www.landroverworld.org/members/tlt.19334/For the spares that you have would you mind measuring the length of the front (short) and rear (long) sensor link that connects to the chassis? Front link should be about 3.5" but wanted to confirm. I have adjustable ones and...- BendRover123
- Post #27
- Forum: LR3
-
LR3 2008 Suspension Height Sensor Linkage
Some more info Front Link: 5K483A Rear Link: 5K483B Is what i am talking about- BendRover123
- Post #7
- Forum: LR3
-
LR3 2008 Suspension Height Sensor Linkage
Hindsight 2020 not the smartest decision in my life!- BendRover123
- Post #5
- Forum: LR3
-
LR3 2008 Suspension Height Sensor Linkage
thanks you cant believe how hard it is to get that data! that is the front, since it has the 90deg twisted head, the rear has both aligned. maybe from that measurement alone i can figure out the rear from the pictures. front: 3.5" rear: ? Best Guess 4.2-4.5"- BendRover123
- Post #3
- Forum: LR3
-
LR3 2008 Suspension Height Sensor Linkage
For the front and rear I am adjusting the connecting rods on my LR3 to stock OEM length. The issue is I threw out the OEM links those that connect the sensor to the wishbones on the car and that can be removed (have those thick rubber grommets). Could any of you help me out for the rear and...- BendRover123
- Thread
- height sensor johnson rods lifting rods lr3
- Replies: 8
- Forum: LR3
-
Replaced rear diff pinion seal, drive shaft and breather
I found the breather line at the fuel filler neck, no filter on mine either and spliced a new line to it and routed it over the rear passenger wheel well, along the lower side board where the aft heater lines run along, over the front passenger wheel well and along the front lower engine metal...- BendRover123
- Post #12
- Forum: LR4
-
06 LR3 P0175 check engine code just came on
Hey any information on what the resolution was?- BendRover123
- Post #3
- Forum: LR3
-
Replaced rear diff pinion seal, drive shaft and breather
I read something very similar in an offroad manual, it said check your differential fluid after you finish your wading trip or day for water contamination. Have you had experience with any contamination or water getting into the Landover Differentials? I wonder what a quick check would look...- BendRover123
- Post #9
- Forum: LR4
-
2012 headlamp lens replacements
Hey I have had much luck with the 3M type scratch removal liquid. Using a drill with a polishing pad. There is a plastic lens clear coat spray you can apply after which seems to hold up ok (used on my friends BMW lenses), also I took my LR3 lights to a car tinting shop they buffed up mine and...- BendRover123
- Post #8
- Forum: LR4
-
Best Overlanding Apple iOS Maps Application
Hey i am looking for a map that can do both, standard road directional guidance and light off-roading navigational support 4x4 where no internet is available. There are many and tons of options though has anybody actually used any of those and are there any user friendly options? Also I am...- BendRover123
- Thread
- application ios maps offroad overlanding
- Replies: 0
- Forum: LR3
