It's probably the wheel bearing. Not to difficult to replace.
But very likely could be the prop shaft. Jack up the wheel and get under the car and rotate the wheel front and back. If you hear a click, it's bad
couple things to know.
If you have the nav screen - the connector has power, ACC and light control line.
constant 12V is pin 1
switched 12V is pin 11.
light control is 12.
however, to get to work properly the BATT goes to 11 and the ACC goes to 1.
I used the line level outs wired to the...
followed you setup and installed this today.
I had to combine the battery and ACC to 12 volts to get it to turn on, but it never turns off. But I wired into the 12V from the nav connector. Do you remember what you connected to?
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.