Recent content by kels83
-
K
Disco 3 keyfob dead
Went through this many times and the most recent time was a bit different because I could not find replacement housings that fit the original metal key part. Option 1: Replace the battery (~$10): If you can open the key fob housing up without damage then it is possible to solder in a new... -
K
tool/trick to remove wires from fuse block?
Lots of pin removal tools on amazon and ebay. It's basically a short piece of metal that slides in to press the detent down and the terminal should slide right out. I like to replace the terminal rather than splicing into wires. Makes for a longer-lasting connection. In my experience with... -
K
Removing a stuck hitch receiver?
Edit: Looks like someone already posted this tip. Original: The plastic hitch cover has ikea-like pictograms that show 1) key, 2) turn, 3) pull the green knob out towards the passenger (US) side. Are you doing #3? If the sticker fell off or if you tossed the cover there are pics on hitch... -
K
New to me 06 Air Suspension Problems
This, get a tool and re-calibrate. Someone probably switched a height sensor and didn't calibrate it. The vehicle "wakes up" during inactivity every 4 hours or so and re-levels (this is what you disabled when you pulled the fuse). If the reading is too far gone, it can purge all the air in... -
K
Seat Cushion Replacement
Guys, the left and right lower seat cushions on these trucks are identical. There are 4 torx screws on the bottom (I forget the size) and one plug for heated seats if you have that option. You can simply remove both seat bottoms and switch them to the other side of the vehicle so the jacked up... -
K
Suspension repaired (compressor) but still...
These discos have multiple "computers" aka "electronic control modules" that read and adjust from different sensors. The LR3 has an Electronic Air Suspension control module, which is likely what this person suggested. However, it sounds to me like the EAS system needs to be re-calibrated...
