Recent content by mateostyle

  1. M

    Coil Springs for my LR4 in the future as it ages

    For the LR4, I ordered this flex head ratchet and can now access the back but on the front right shock with a standard 15mm like that comes with a craftsman ratchet set: ARES 42026-3/8-inch Drive 72-Tooth Flex Head Ratchet - Premium Chrome Vanadium Steel Construction & Chrome Plated Finish -...
  2. M

    Coil Springs for my LR4 in the future as it ages

    Appreciate the feedback. I have a flexible swivel ratcheting wrench on the way now.
  3. M

    Front Air Struts - time to replace...what else "while I'm in there"?

    On the passenger front side (Left hand drive), how do you get to the back nut on top of the air strut? Would greatly appreciate any insight on this conundrum. Thanks
  4. M

    Coil Springs for my LR4 in the future as it ages

    I replaced the drivers side (left hand drive) air strut on the LR4 last weekend but could not get to the back nut on the passenger side. Is there a trick or tip on accessing that back nut? Tnx
  5. M

    CEL: Barometric Pressure Sensor

    I cleaned mine and didn’t use the Gap IID. Don’t know if I was just lucky or if Gap is just good practice.
  6. M

    Transmission Slop

    Check the U joints on drive shaft.
  7. M

    CEL: Barometric Pressure Sensor

    Thanks for the help - problem solved. I cleaned the throttle body as suggested (toothbrush + throttle body cleaner for pivot points) and threw on a new gasket while I was at it. No more P0106 codes. Appreciate the tips.
  8. M

    throttle body on 5 litre LR4?

    Is there anything special on the LR4 to take throttle body off for cleaning? Do you have to do anything for the throttle body to relearn the position after removal and cleaning? Thanks.
  9. M

    CEL: Barometric Pressure Sensor

    Thanks - Will give it a try.
  10. M

    CEL: Barometric Pressure Sensor

    Hi all, received the P0106 code a few months ago, replaced the MAP sensor with genuine part (thanks to this thread) and code CEL went away for 5k miles. Over the weekend the CEL came back on and it’s the same P0106 code. I saw another poster had the same experience. Any thoughts? The LR4 has 70k.
  11. M

    Is it possible to remove the middle seat

    I couldn’t find anything else online about removing the seat. The forum was a good resource google pointed me to when searching for “LR4 middle seat removal”. Easy 10 min job counting toting the removed seat down to basement and putting socket and torx 50 back in the toolbox.
  12. M

    Is it possible to remove the middle seat

    On the LR4 it required the removal of six bolts; two forward and four bolts on the rear of the seat. No wiring or anything else to deal with. Once all six bolts are out, roll folded seat back and take out through the rear of the car. Makes LR4 look like it came with captains seats (almost) from...
See more

Latest posts

Members online

Total: 443 (members: 3, guests: 440)

Forum statistics

Threads
36,271
Posts
218,116
Members
30,497
Latest member
TeriM

Share this page

Top