Tapps33
Latest activity Postings About
-
-
Tapps33 replied to the thread Bad ECM or something else?.They will get hot, but typically they’re only gonna get hot when you’re really Pushing the engine hard and it’s hot out. Sitting at... -
Tapps33 replied to the thread Bad ECM or something else?.A couple thoughts… I think you’re looking in the wrong place. If the whole OBD2 system is down, I would be checking the connector...
-
Tapps33 replied to the thread Project Dark Knight Rising.Yes, I've been looking at that. It still has the same charge cooler design though. I mean, that's the great thing about it, it's 100%...
-
Have you seen the VelocityAP / Harrop TVS2300 supercharger upgrade for the V8SC? Direct swap, 20% more SC displacement
-
Tapps33 replied to the thread Project Dark Knight Rising.No, I’m looking at something to increase airflow and reduce temperatures…and allow me to possibly swap out for a larger SC. I’m...
-
-
Tapps33 replied to the thread 2015 LR4 - Major engine work - Sell / Sell Parts.Honestly, for the cost, I'd try and sell yours as a fixer and just get another used one. In the end you're going to come out WAY ahead...
-
Tapps33 reacted to TimVZ's post in the thread 2015 LR4 - Major engine work - Sell / Sell Parts with
Like.
@Tapps33 - Correct, not (enough) time or tools. I looked for a few independents and most didn't have the tools or comfort level with the... -
Tapps33 replied to the thread 2015 LR4 - Major engine work - Sell / Sell Parts.Ok, lemme first say I'm looking at your pictures, and the damage....if any, isn't all that bad. I've seen these engines run just fine...
-
Tapps33 replied to the thread Project Dark Knight Rising.No, unfortunately I didn't take any "pre-sanding" measurements save just putting my straightedge against the block and looking for...
-
Did you take any kind of measurements before to see how out of ‘flat’ it was to begin with? Did you see any obvious signs of of head...
-
Tapps33 replied to the thread Project Dark Knight Rising.OK, so I finally got a little work done this past weekend. It took me roughly a day or so to get my deck prepping tool made...and that...
-
-
Tapps33 replied to the thread Project Dark Knight Rising.Thanks! I appreciate the support! I've got the heads back off and am taking them to the machine shop sometime this week to be...
-
-
Tapps33 replied to the thread Project Dark Knight Rising.I plan on pulling the heads, again, to get them re-checked at a shop near me. Maybe they got damaged during the move to TN or...
-
I’m sorry to hear. Stiff upper lip. Get the block head and heads checked. With you there.
-
Tapps33 replied to the thread Project Dark Knight Rising.Well folks....it's been a rough weekend. Turns out, I didn't screw up and nothing broke, and the timing is dead on. Then I went and...
-
-
Loading…
-
Loading…
