Recent content by sailor96
-
LR4 5.0L V8 MAP Sensor Replacement DIY
Great write up- I replaced the MAP sensor with LR OE part- was good for a about 3 weeks- CEL came back on twice in the past week- throwing the P0106 code- Cleared code with iSoft tool. Ran the **** out of it- luckily no speeding tickets. Trying to figure out if there is more going on or is it... -
LR4 Hood Release cable broken at cable junction
2013 LR4- I've seen threads that address broken hood release cable at the release lever in the cabin. Mine has broken at the junction of the 2 cables under the hood. I was able to grab the cable on the right - passenger side and pop that latch and secure the cable and then grab the driver side... -
ARB Summit Bar - 2013 LR4
@TrinidadLR4 were you at the last Roam event in douglasville? -
ARB Summit Bar - 2013 LR4
Check with Mainline Overland in Westchester PA- they may have them-doubt it but worth a shot- By the way- I have the 14 & up bumper on my '13 LR4 and installed the fog lights myself- plugged right in- I do need to note- that the connectors were already added by shop that did electrical work- so... -
18" Wheels w/o modifications
Link for Evo Course wheels Pricey- no mods https://www.mainlineoverland.com/collections/evo-corse-dakar-wheels/products/evo-corse-dakarzero-18x8-5-land-rover-lr4-5x120-et-35 -
18" Wheels w/o modifications
I run the Compomotives with 265/65-18's KO2's. Check out Evo Course on Mainline Overlands website. They fit LR4 without mods as well. -
Question for LR4 owners that switched to 18" wheels
Mine have white lettering on one side. -
Question for LR4 owners that switched to 18" wheels
Also, run the 18" Compomotives with 265/65-18 KO2's. No rubbing issues. You'll hate the first time you get rock rash. There is another option- Evo Corse- pricey- $370.00 per vs $325 for the Compo's @ johnson rods... -
18’ wheel suggestions for my black 2010 LR4
There's another option that does not require spacers: Evo Corse DakarZero 18x8.5 Not cheap at $370 per Size: width 8.5”, diameter 18”. - Material: Aluminium A356 alloy with heat treatment T6 and low pressure cast in steel permanent mould. - Load Rating: 1,300kg per wheel. - Nut fixing: steel... -
Integrated Front Bar / Winch Mount
I'm just throwing an option for @AdventureTim - I don't know or care what you think is obvious or what your comfortable or not comfortable with. -
Integrated Front Bar / Winch Mount
Better yet there's a Terrafirma forum here. https://www.landroverworld.org/threads/terrafirma-hidden-winch-install.29560/ -
Integrated Front Bar / Winch Mount
Take a look at Terrafirma descreetwi ch mount. https://www.roverparts.com/Parts/TF097?gclid=CjwKCAjw5fzrBRASEiwAD2OSV65yh2q--KY8eGz-NljkN3D9WgEeOEe0wZBAkz41bHo0dKkDVN2HhRoCVkUQAvD_BwE -
GAPIID Recommended Updates
I went directily to GAP Diagnostics- these are an essential tool to have -
Showoff Your LR4
George Washington National Forest near Edinburg VA.
