I had the same thing happen to me. Pliers and xacto knife to scrape plugs out. Then, tap the threads to clean out the hole. In The 2013 model I have, the plugs were basically glued into the hole.
Adding to the conversation, Atlantic British has a trailer brake controller you can buy to. It just basically plugs in and you’re all set.
Sent from my iPad using Tapatalk Pro
Thanks! Your memory is good. Straight forward install. I reused the negative side plastic plug on the stock battery for the negative side vent and just plugged in the plug/connector for the positive side vent. All other connections were spot on. I ended up going with a East Penn/Deka Gold 694RMF...
If you had to dig out the plastic plugs installed from the factory, you may not have got them all out completely. When I did mine, I was surprised how deep the bolts went down. I wouldn't torque beyond spec, you could strip the threads in the holes and cause more problems.
Clever, thanks for the post. In my case, this method may have worked but my rig has seen 3 winters with road salt. The plastic part inserted into the holes had essentially been bonded with rust and grime, so I could not unscrew them. Ended up popping the cap part off, drilling into the hole...
Great post and good looking rig. How's the wind noise with the rack up there? I expect noise when stuff is strapped down but wonder if barebones rack is noisy.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.