Search results

  1. scapistron

    Rubber suspension trim part number

    https://landrover.scuderiacarparts.com/part-finder/landrover/discovery/oe/500/5371/107459 That should get you going in the right direction.
  2. scapistron

    O2 Sensor Identifications - and intermittent CAT code troubleshooting

    Intentionally misnamed device. It goes between the 02 sensor and the exhaust.
  3. scapistron

    Oil Reminder

    I try to remember while leaving the grocery store or hardware store and usually forget.
  4. scapistron

    Camshaft regulator failure - advise needed

    You might be able to get away with a new head and timing chain. Depends on if the glitter caused any other scoring from the metal.
  5. scapistron

    Oil Reminder

    I've long thought about an oil reminder to put over the start button. If I had a 3D printer, it would be some little flip up cover like a fighter jet. I don't have a 3D printer though, so I went with PBAD instead. Paper board aided design. Whenever I want to check the oil the next time I get...
  6. scapistron

    O2 Sensor Identifications - and intermittent CAT code troubleshooting

    Sensor 2 is mid cat. Sensor 3 is post cat, this is where system efficiency is measured. You've got choices based on where you live. If you live in an emissions free state, nothing is a reasonable choice. You'll just have to check every now and again that you don't have any other codes. New...
  7. scapistron

    Control Knobs

    Baking soda worked really well.
  8. scapistron

    CEL for minor errors on IID tool?

    I live with the same headlamp code and it doesn't trigger a CEL. I'd double check that the secondary battery code is the same one you had been seeing. I thought I read that when the secondary battery is just old and tired you get the start stop light. When the secondary battery is dead you...
  9. scapistron

    Control Knobs

    Tub o towels in my case.
  10. scapistron

    Control Knobs

    Anyone know the part numbers for the control knobs? I may have gotten a little aggressive with the cleaning and they are all very gummy now. If not I may just try to finish the job with an eraser wheel.
  11. scapistron

    Persistent misfire under load only

    This is when I start getting the parts canon ready. Just start replacing sensors from easiest and cheapest to the most PITA ones last.
  12. scapistron

    Found 13mm nut underneath LR4

    Sway bar end link nut? Looks too greasy to be from the exhaust.
  13. scapistron

    Crazy to consider new engine in a 2016 LR4?

    I really want two joke products for my LR4. 1. A start/stop button that is either "finger's crossed" or "hands together prayer" emoji. 2. A trailer hitch brake light that is the universal check engine symbol.
  14. scapistron

    At Long Last... Modern head unit!

    I have not been having much luck with the mr12volt. First I was sent the wrong module. It took a little back and forth to get that sorted. I got what I presume is the correct module as it says "Discovery 4 2012-2015". After a little more trouble shooting I got my phone to connect and the...
  15. scapistron

    Persistent misfire under load only

    Just the bank. I'd probably start launching the parts canon, but I'm more of a replacer than a proper technician. 1. Low pressure fuel pump and low pressure sensor. 2. Fuel injectors. 3. High pressure fuel pumps. I'd probably go in that order.
  16. scapistron

    Persistent misfire under load only

    If you are getting a misfire on any cylinder, it could be any fuel injector on the whole bank. I had a stuck open injector on 4, driver's side front that would set off a cascade of misfires as the computer tried to adjust from the rich condition this caused. The feedback loop was something...
  17. scapistron

    p003c

    When I replaced the motor in mine I opted for flanged bolts over the torx fasteners in a lot of places. Little bit of masking tape inside the 10mm and they press fit in there. Just don't lose your 10mm.
  18. scapistron

    2011 5.0 head gaskets

    Are you trying to get the coolant system to run at a slightly lower pressure?
  19. scapistron

    Thought the front end structure was an aluminum casting

    I drilled a couple of holes in mine and collected all of the chips so I could light them on fire.
  20. scapistron

    LR4 Seat Covers

    This reminds me that I really need to get some sort of cover for the center console. I have a dog that thinks it is a great place to stand.
  21. scapistron

    Persistent misfire under load only

    I think positive values are the sensors asking for more fuel. Probably should smoke test your intake.
  22. scapistron

    2016 LR4 Landmark SCV6 Engine Failure at 65k. WWYD?

    My biggest problem with the dipstick in dash is that I'll want to check it, but muscle memory is to put my foot on the brake and push the button.
  23. scapistron

    Dead mouse inside my fan motor blower

    Deleted
  24. scapistron

    Crazy to consider new engine in a 2016 LR4?

    You can't bore these motors. The cylinder liner is a nikasil coating.
  25. scapistron

    Dead mouse inside my fan motor blower

    Hot tip for everyone. Slide a piece of sheet metal in between the filter and the blower, then remove the filter. I regret not doing this today, a five minute filter change has snowballed on me.

Latest posts

Members online

No members online now.
Total: 1,319 (members: 0, guests: 1,319)

Forum statistics

Threads
37,146
Posts
226,329
Members
31,263
Latest member
KyleK951

Share this page

Top