Search results
-
Transmission “Free Wheeling”
I would disconnect the battery for 15 minutes. That will clear the transmission learned adaptations. See if that helps.- Rover Range
- Post #2
- Forum: LR4
-
Discovery 4 sdv6 GS Dreaded suspension fault help needed
What DTCs do you have? Throwing parts at it will cost you way more than a proper diagnosis.- Rover Range
- Post #2
- Forum: Discovery
-
2020 Range Rover Sport Hse - Crank but no Start, after accident , fuel pump not working
The restraints module (SRS) has locked out the fuel pump. The module will need to be replaced with a new one and reflashed .- Rover Range
- Post #2
- Forum: Range Rover
-
-
Water Pump & Outlet Pipes Replacement
Supercharger doesn't have to be removed to replace the front crossover pipes.- Rover Range
- Post #7
- Forum: LR4
-
Open to Suggestions
Better hope the new sensors are good. :rolleyes:- Rover Range
- Post #48
- Forum: LR4
-
Passing Wires from the Engine Bay through the Firewall to the Cabin
Follow the hood release cable where it goes through the firewall. Use that grommet to route your wires.- Rover Range
- Post #2
- Forum: Range Rover
-
Zip kit and fluid change, now won't go past 5th
Either low on fluid or the shuttle valve at the manual linkage not in the proper position.- Rover Range
- Post #5
- Forum: LR4
-
Open to Suggestions
Some vehicles have a symposer. Which is attached to that fitting. The vehicles that don't have it, the port is capped off. The symposer creates a V8 like sound on acceleration.- Rover Range
- Post #32
- Forum: LR4
-
Mysterious Rear Thump Clump
Have the dealership diagnose it. I'm sure they have heard the noise before. Guessing can get expensive.- Rover Range
- Post #4
- Forum: Discovery 5
-
Persistent P0430 on my 2012 5.0
Only the one. The only sensor that monitors the cat efficiency is the very last one.- Rover Range
- Post #8
- Forum: LR4
-
Persistent P0430 on my 2012 5.0
A bad sensor won't cause that DTC. Convertor needs to be replaced. Or, get one of these. They do work...- Rover Range
- Post #5
- Forum: LR4
-
Check engine light on
The factory tool is much better. The DTCs you listed would trigger a different warning light.- Rover Range
- Post #14
- Forum: LR4
-
Check engine light on
GAP tool may be sending you on a wild goose chase.- Rover Range
- Post #12
- Forum: LR4
-
-
No start / no dash display after battery replacement
Can you hold the key fob under the steering column and cycle the key on?- Rover Range
- Post #4
- Forum: Discovery
-
No start / no dash display after battery replacement
Try disconnecting and reconnecting the battery. Check the battery ground cable at the body ground. Telematics module could be causing your issues.- Rover Range
- Post #2
- Forum: Discovery
-
Transmission Heat Shield
On the L405 and L494 models. There is a bulletin to remove completely, the bracket and heat shields. Those models, there is a lot less framing around the transmission.- Rover Range
- Post #4
- Forum: LR4
-
Valve cover gasket replacement ($3,200)
Nothing breaks when doing valve covers. $3,200 seems excessive. The job pays 8hrs. Plus seals.- Rover Range
- Post #2
- Forum: LR4
-
Transmission Heat Shield
Bracket needs to be replaced with this part # LR073535 And foam pads installed on bracket. Part # LR044464- Rover Range
- Post #2
- Forum: LR4
-
Open to Suggestions
You can put the hood in service mode for more room. Disconnect the hood struts and flip the hood vertical. Then flip the locking tabs into place.- Rover Range
- Post #20
- Forum: LR4
-
code P2096
Try running some BG 44K in a couple tanks of fuel. Stuff really works.- Rover Range
- Post #7
- Forum: LR4
-
steering clunk: upper U-Joint?
You can try retracting or extending the steering wheel and see if the slack changes.- Rover Range
- Post #5
- Forum: LR4
-
Noise coming from left rear area
Could be a rock in the brake backing plate. Seen that before.- Rover Range
- Post #8
- Forum: LR4
-
Noise coming from left rear area
When the braking friction material separates from the brake shoe, the material can get jammed on the drum. This can make the rotor difficult to remove. Wheel bearing noises can be ruled out by driving the vehicle and swerving left to right. See if the noise changes.- Rover Range
- Post #5
- Forum: LR4
