Search results
-
B
EBC Rotors + EBC GreenStuff 6000 Brake Pads Feedback
Ceramic pads? Thanks good to know making a note. Didn't the D2's have vented fronts and solid rears? D1'a were solid both ends. Rotors were repaced by PO with plans on keeping the D1 at end of 5/60K lease in 1-2000. Purchased it 1-2000 and had his 7/100K warranty that paid for the 4.6... -
B
Repeatable Vibration Issues
Had to ask reading you also have wheel spacers. I installed Terrafirma's 30 mm spacers and had instant vibration issues on the 95 D1. Not a clue about D2's, LR3's and anything newer on how the lug nut design is on later LR's. Two issues, one the Terrafirma spacers are centered by cone nuts to... -
B
Repeatable Vibration Issues
Michael Gain, sounds like you've done a lot of work and parts replacing with frustration being end results sorry to hear. Right away mentioning rubber dirveshaft joint brings up a red flag, they are a POS in my opinion vs a true steel cross U-joint. Had issues three times on the 95 D1, first by... -
B
EBC Rotors + EBC GreenStuff 6000 Brake Pads Feedback
ktm525, i've seen many times these factory maximum spec limits hard to measure due to loose wheel bearings due to normal wear, not cleaned, inspected, repacked or replaced and properly adjusted. Properly adjusted another JMO mouthful of differnt answers be it slightly detectable play, zero play... -
B
5.0 Reman Engine Supplier
Can you elaborate more why "it's hilarious" for the LR parts only to see FoMoCo stamped all over everything! ???.....~~=o&o>...... -
B
Engine swap
DirtyHal, there smog checks in your state plus they allow different engine brand swaps with different displacement increase still able to be plated in your state? Had to ask as Kalifornia one of the worst smog Nazi states with Connecticut just as strict. Kalifornia. One other state rounding... -
B
Engine swap
This article sent to me by a now "ex Dodge truck owner who found issues with the V6 engine;https://carbuzz.com/news/why-new-ecodiesel-owners-need-to-beware-of-engine-failure. Weight of V6 must be heavier than the aluminum V8 to also consider. Sad a manual transmission is not available as that... -
B
Trailer light question
With 12.6 volt typical vehicle system voltage your around 16 watts or app 55 BTU/Hr heat generated at the power resistor. Mount it in an open area allowing heat dissipation and not up against anything. Any 25 watt power resistor will run a lot cooler than a 15 watt unit costing more plus larger... -
B
2013 LR4 5.0L Cold start knocking noise
Unusual or any other noises means something is wearing away. Run long enough it will finally become evident what had failed that even Stevie Wonder can diagnose.....~~=o&o>....... -
B
2013 LR4 5.0L Cold start knocking noise
If that's the fan clutch ticking while the fan is slowly spinning less than engine driven fan pulley speed you should then have a higher rpm ticking sound when the fan is carefully slowed down and stopped. BTW you living in a cold climate a block heater would be a good idea reducing cold warmup... -
B
Just hit 49,000 miles - extended warranty or roll dice?
Must add while Disco was in the dealership seven weeks waiting for replacement engine D1 hood became a storage space. On big cardboard box weighing 30 plus pounds dragged across the factory like new black gloss hood making two long scars in the finish. Engine removal by forcing the hood... -
B
AC isn’t cold
Pablo1987, did you check with both AC gauges to see if the high side is reading too high as well the AC system short cycling? This would point to the expansion valve not operating properly, stuck partically closed and failing. They are cheap while system is opened up. As with any AC system... -
B
Should I buy an extended Warranty?
Had to ask, how many Cats did you replace costing you $2,200 and were they replaced by a LR dealership or by a local muffler shop? Replacement due to a "spoiled" Cat due to engine misfiring, coolant or oil leakage into the exhaust system or mechanical off road impact damage to...- BeemerNut
- Post #9
- Forum: Range Rover
-
B
Johnson loft and spacers
Lucky-8 sells Terrafirma 30mm wheel spacers, do note they are NOT DOT APPROVED for the open road and losted as for OFFROAD ONLY. Depending on how sharp (Nazi) or stupid (Goober) the officer is and state your in it or you can be questioned. A caution note, Terrafirma proudly state their spacers...- BeemerNut
- Post #8
- Forum: Discovery 5
-
B
Johnson loft and spacers
ar007, I had to ask, was there any back space difference and if any by how much switching from the 8.5" rim to a 9.5" rim? If the 9.5" back space is the same as the 8.5" rim then there is no issues plus you gained having a wider track stance overall times two (each wheel). If the added 1" rim...- BeemerNut
- Post #7
- Forum: Discovery 5
-
B
Just hit 49,000 miles - extended warranty or roll dice?
As mentioned above, third party extended warranty companies not covering LR's including a southern Calif. company called Western General. Hard as hell to get approval any repairs by them stalling for weeks,, hell months one time. Coverage for the failed part only plus way over too epensive... -
B
Rear Rotor Will Not Go On 2010 LR4 V8
Overthinking a simple problem can cause frustrating moments on your part biting you in the butt. The pisser, who to blame in these cases as the answer hurts. Hands on your best teacher, congrats on your successful ending......~~=o&o>......... -
B
Tech requirements, driving a Euro LR4 in US/CA
Shipping fees plus all the red tape and hoops you must jump threw as well California being one of the top three states with the strictest smog laws, you must hate yourself. Why not save your money and buy a used LR in California, drive it then sell when your ready to depart? To comply with added... -
B
Intake Valve Cleaning
My apolgy to the cammer engine section. This morning my D1 Discocover ONE friend opened up his laptop and had this thread opened up telling me about a "Disco One" carboned up issue. I took the opened thread and ran with it what I used on my group of Disco ONE owners having them maintained geared... -
B
Intake Valve Cleaning
Your starter thread question "regards to the valves valves on our D1 engines". That covers 1994 to mid 1998 3.9/ 4.0 with a few 4.6 push rod engines sold in the US including 1990 3.5 engines sold in Europe. Your thread went off track highjacked instantly into LR3 & LR4 series OHC engines with... -
B
LR4 whining noise turned into a loud clicking noise now
Cloth strap wrench will not damage the pulley one bit, this should of been an easy fan removal. If you had a cast iron idler pulley most LR's had a snap ring (older D1's) allowing a $6.45 quality brand sealed bearing replacement, not some POS bearing from China. Even the cast iron idler when the... -
B
Advice for Brake Shake
Besides left and right rotor wobble you can also have a condition where the rotor has swelled or thicker spots vs normal thickness of the rotors especially vented vs solid. You by chance come to a hard stop from highway or down hill mountain driving ending up in water deep enough to submerge...- BeemerNut
- Post #8
- Forum: Range Rover
-
B
3K oil change intervals for our LR4s?
Sad how over the years diesel was not allowed in the U.S. given they are refined engines not like an old fishing boat diesel of years gone by.......~~=o&o>...... -
B
3K oil change intervals for our LR4s?
Modern day engines having tighter tollerances, manufactures pinching every tenth of a mpg out of their vehicles do recommend rather thin low viscosity oils. Say as example OW 5-20 wt oil, by 60 or 80K miles rods and mains plus cam journals have worn increasing internal clearances. Maintaining... -
B
3K oil change intervals for our LR4s?
Yeah and it took a Canuck to straighten out the U.S.A. resident LR owner.
