Search results
-
-
Break in the MOST ring? Fiber optic interconnect
I've never seen a broken MOST ring. Not to say it can't happen. When you disconnect the MOST connector, you should see a red light in the module's connector cavity. Satellite modules are usually the culprit.- Rover Range
- Post #17
- Forum: LR4
-
Break in the MOST ring? Fiber optic interconnect
Purchase the optic bypass loops and try to bypass each module on the MOST Network. Bypass the modules one at a time, cycling the ignition on each time.- Rover Range
- Post #15
- Forum: LR4
-
-
Vibration
Sound like collapsed front motor mounts. With the hood open. Foot on brake. Do not let off brake. Place in drive. Give a little gas and see if the engine jumps up. If it does, mounts are bad.- Rover Range
- Post #2
- Forum: LR4
-
Newbie LR4 questions - thanks!
3) To remove the headrest. Push the tab on the right side, while lifting up on the headrest. When the headrest stops, push the tab on the left side to fully release.- Rover Range
- Post #8
- Forum: LR4
-
08 RR HSE LR4 4.4 Fuel Gauge reads 3/4 full when filled
Both fuel senders will need to be replaced. There's an access port on the left side of the tank to get to the left sender. Fuel pump is on the right side.- Rover Range
- Post #5
- Forum: LR4
-
Transmission error P1707-77 и U0402(00) Land Rover Discovery 5 2018
The P1707-77 DTC could be caused by the manual park release cable sticking. Look under the hood, on the left side. You will see a short lever that is used to the park pawl. Cycle the lever a couple time and make sure it is released back to the down position. This can also trigger the other DTC.- Rover Range
- Post #2
- Forum: Discovery 5
-
-
Oil level sensor leaking
Hence, the main reason I'm here.... Not to brag. But, I have 16 years with the brand. :rock:- Rover Range
- Post #9
- Forum: LR4
-
Oil level sensor leaking
The oil pan doesn't have to be removed to replace the oil level sensor. Drain the oil. Remove the three bolts (Torx T30). Remove sensor, reinstall. Refill oil.- Rover Range
- Post #7
- Forum: LR4
-
LUX vs Vision package
"Less" means not included. The rear frame will have the provision for the hitch adapter. The trailer wiring is ran all the way to the left tail light. You will need the adapter harness to complete the wiring to the hitch...- Rover Range
- Post #16
- Forum: LR4
-
LUX vs Vision package
7 SEAT CONFIGURATION 20INCH 10 SPOKE ALLOY WHEEL 255/50 R20 AT 7143 LBS USA/MEXICO ADAPTIVE BI-XENON H/LMP NAS AMBIENT LIGHTING AMERICAN MOBILE PHONE SYSTEM ANALOGUE AUDIO BROADCAST ATC AIR CONDITIONING AUTO HEADLAMPS-FOLLOW ME HOME AUTO HIGH BEAM ASSIST AUTOMATIC GEARSHIFT AUTOMATIC HEADLAMP...- Rover Range
- Post #13
- Forum: LR4
-
-
400a fused burned - what could cause this?
Usually caused by a poor ground to the engine block.- Rover Range
- Post #3
- Forum: LR4
-
LR4 "Gearbox not in Park" - Dial shifter stuck in Drive
Rotary shifters are plug and play.- Rover Range
- Post #8
- Forum: LR4
-
parasitic drain?
You need to verify if the vehicle is going to sleep. The red light in the hazard button will go off, when the vehicle is asleep.- Rover Range
- Post #4
- Forum: LR4
-
2021 Defender headlight Halo Lights out
They do. But, you never know what you get. May have the same issues.- Rover Range
- Post #5
- Forum: Defender
-
2021 Defender headlight Halo Lights out
- Rover Range
- Post #3
- Forum: Defender
-
-
Water on passengerside floor board (not sunroof drains)
Not hard to do. A pillars are not fully sealed. Water drains outside of the vehicle.- Rover Range
- Post #18
- Forum: LR4
-
Relay R1, 2011 LR4
The park lamp relay in the fuse box behind the glove box. Relay R10.- Rover Range
- Post #4
- Forum: LR4
-
Relay R1, 2011 LR4
The headlamp relay is in the engine compartment fuse box. Relay R11. Should be a mini relay.- Rover Range
- Post #2
- Forum: LR4
-
SYA Kit, suspension not calibrating.
"Air suspension in customer service mode." Means the suspension was put in the tight tolerance mode, possibly for an alignment. There's a manual way to put the vehicle into tight tolerance mode. With a series of brake pedal presses etc . This may have been inadvertently done at some time.- Rover Range
- Post #2
- Forum: LR4
-
5.0L Crankshaft Seal Leak, Request Advice
Coolant pump doesn't have to be removed. Pulley is pressed on to the coolant pump.- Rover Range
- Post #17
- Forum: LR4
