Search results
-
2011 LR4 Suspension code U3000-1D
A quick search also yielded some other posts, does look like the U3000 is suspension related. https://www.disco3.co.uk/forum/post2378943.html https://www.landyzone.co.uk/land-rover/rr-sport-2010-air-compressor.378006/#post-5333187 https://www.rangerovers.net/threads/suspension-fault.352250/ -
2011 LR4 Suspension code U3000-1D
This U3000-1D doesn't mention suspension at all, could it be unrelated to your changes (other than the timing of the suspension raise request)? Is your battery OK? Bear in mind these things are super sensitive to dying batteries. I assume all the electrical connectors are OK? -
Beep beep
The phone blocking makes sense but the driver sides doesn't. I need to look at where the sensor is located in the vehicle and see if that's somehow impacting the behavior. Not sure yet what parts to be looking at... I thinking opening behavior is OK though, what's with that! -
Best way to clean out sunroof drains
In the sunroof area they're in the front corners, you see a little channel that leads to the hole but this is all really small stuff... The hole in the intake area can be found behind the foam block, it's not overly obvious so just keep looking you'll see it eventually. Top clean mine out I... -
Beep beep
Hey Folks - I mentioned this in the past but have a little more bandwidth at the moment to look at this issue... I notice that when pressing the button on the drivers door handle to lock the car I often get the "beep beep" noise and the car won't lock. If I move around ever so slightly in the... -
2010 LR4 Air suspension need advice
I'd also say it's a pretty subtle white residue, replace the o'rings, use a very small amount of silicon grease on the new ones and generally give the whole block a good blast with an air nozzle and wipe down all the internals. -
Sudden Hissing near Valve Cover (5.0 V8)
Replacement looks really easy so not a biggie! -
2010 LR4 Air suspension need advice
Why not just service the valve block, you'll save some $$$'s, have familiarity with the workings of the valve and honestly it's not that difficult. It's a pretty simple device so overall the mechanism portion of the valve block is unlikely to deteriorate over time, it's just the o'rings that... -
LR4 Window problems
Reset Procedure: "With the engine running. Windows closed. Lift up on the window switch, hold for 5 seconds and release. Repeat once." Worked beautifully, my drivers door window is behaving again. Thank you @Rover Range. With that I ran the test for @txfromwi, I can confirm there is a... -
Sudden Hissing near Valve Cover (5.0 V8)
Thanks for making me aware of the brake switch clicking noise, I was blissfully unaware until reading this thread and now I can "happily" report that I also have a loud clicking noise - great!!! :ahhhhh: -
LR4 Window problems
I'll test mine and report back once I've applied the reset. -
2010 LR4 Air suspension need advice
What parts are you thinking of in particular? For the compressor I went OE (AMK - bought and shipped from the UK as I believe I mentioned in the post above); for valve seal kits I believe it was Land Rover of Utah (it's posted in the thread above and I know others have had success with this... -
LR4 Window problems
Nice - thank you so much, you've made my day is this is super simple :-)... -
LR4 Window problems
I just ran in to this issue on my drivers door, I suspect it's sensing too much load when fully closed and then winds the window down again (like you have something stuck in the window!). My question; how do you reset the window as mentioned above? Thanks. -
2010 LR4 Air suspension need advice
I agree with the advice here, I'd start by servicing the front valve block, if you see lots of desiccant then start looking at the canister on the compressor. I believe that the Hitachi compressor has the serviceable canister, not sure about AMK as I replaced mine when tackling similar issues... -
steering wheel
I don't think so, look around on here, I believe I've seen others attempt this. -
Intermittent clicking sound at idle 5.0L V8
I had this happen recently, started a thread on the same somewhere here in the forum, same bearings were completely shot! This then lead to me doing the timing chains! Here's the thread... -
2015 LR4 Windshield Wipers
FWIW - I installed a new rear wiper recently (PIAA from Amazon - fitment is not great as the center clip is too large); I noticed that the rear wiper arm was quite stiff at the spring pivot point so I used a small amount of silicon grease and gently moved the wiper arm back and forth to help... -
Timing Chain parts
No problem, send me a PM with your email and I'll send it your way! Also have one with cooling system parts if needed? -
Looking to purchase timing chain tools
Happy to send the docs, please PM me with an email address and I'll send you the documents that I have; I didn't go with a kit as I never found them to be exactly what I wanted. I also have a few parts that I never needed if you're interested (they're genuine parts collecting dust at the... -
2015 LR4 Coolant Issue - Nothingburger or...
Absolutely agree with jlglr4's comments above; there's no need to panic yet but keep an eye on that coolant tank. I did the front/rear crossovers and all the pipes recently while doing the timing chains. You need to look as indicated here: Here's a closer up (now with the oil cooler pipe in... -
Where is my coolant going??
You seem to have the same issues as this parallel thread: https://www.landroverworld.org/threads/2015-lr4-coolant-issue-nothingburger-or.45865/ If fluid is going down then you have a leak, how long does it take to go down, what's your mileage? Check the normal places, cross overs (front and... -
2015 LR4 Coolant Issue - Nothingburger or...
I'd start by filling up the reservoir tank and keeping an eye on it to see if it goes back down again. The weaker points on this particular engine are the front and rear crossovers and the small pipe that goes from the water pump to the oil cooler... If it's a really slow leak then perhaps...
