Search results
-
T
Where's the leak?
Where are you located? What year / mileage? Have you gotten under and around it with a spray bottle with some soapy (think dawn) water.. Let's figure it out. -
T
just clarification here
Typically it would expect that you should check all your wheel bearings, and then check the rear diff. I'd guess it's the diff. Could also be a few other things but that's going to be the common ones. Let me know if I can help once you sort it out. -
T
Transfer Case Play (Video)
hmmm. thinking about this. Bear in mind, the drive shaft wouldn't rotate if there wasn't some slack in the diff. Do the video again on the flange of the diff just for kicks. -
T
LR3 Light Bar install wiring question
If you prefer not to do any guessing, then do the remote, you do not have to tie into the LR wiring at all. The main thing if you are running the wire to the cab is to use the grommet if that is the route you are going. I have wiring diagrams if it helps, drop me a line w/email. -
T
LR3 Light Bar install wiring question
OK, so what do you think of the remote relay method? Be sure once you have it installed (even with a Rigid) to pump the wire sheath full of clear rtv silicon so it does not fill with water. -
T
Interior temperature
I doubt it. If they took the time to install a sensor, they would probably have displayed it somewhere. Due to a vehicle and heating or cooling it being about like heating or cooling a barn, the temp would not be very consistent I suspect. Something Amazon.com - 1 X Mini Digital LCD Thermometer... -
T
Rear glass door got entangled in garage door - broke struts
The struts were upgraded at some point in time to work better if one failed. Did you rip the stud completely out, can't make it out in the picture. BHE780060 is the part I ordered, it's been a while though. They only come as the strut, no mounting studs, because they snap on the studs. If you... -
T
LR3 Light Bar install wiring question
The way I did mine was to install a remote relay, so it is not tied into the high beams. When I want to use the light I press the remote button. This enabled me to not have to run wires for the switch, etc. Happy to send you links to the pictures. Info on the remote relay kits, etc. Where are... -
T
How to check the battery voltage with the settings menu
I recommend you go with a Deka Intimadator series AGM. -
T
Front Windshield Leak
I went with Pilkington glass Non OEM.. Same thing and a lot cheaper, happy so far. -
T
Front Windshield Leak
If your sunroof is plugged it would run down the roof liner, might manifest itself with some drips out of the overhead console where the lights and sun roof switch are. It really does not seem like it should be that complicated to fit and seal a windscreen. I haven't had any leaks with my new... -
T
How to check the battery voltage with the settings menu
You are not going to get an accurate determination of the battery voltage when you have a load on it, aka the Nav screen, etc. If you have 12.0 v when the vehicle is not running, then you would likely be getting some random errors when starting, or other times, so it might to time to do a... -
T
How to check the battery voltage with the settings menu
A multi-meter is your friend. -
T
No, I don't need gas!
No big deal on LR3 vs LR4 thread. Maybe you have a bad sending unit.. Where are you all getting your capacity information... CAPACITIES The following capacities are approximate and provided as a guide only. All oil levels must be checked using the dipstick or level plugs as applicable... -
T
Various modules and fault codes, hard shifing
Mileage, Year, Engine? You can start with voltage shut off, and running. If the brake light switch has never been changed, change that, check brake light bulbs as well, though I suspect something else may be going on. Any service history on the transmission? -
T
LR3 Hesitation during take offs
I have done the pedal trick, just to see if it worked, it did, no harm. I would use an IID tool though if you have one... no specific reason. I would add, the valves are known to gum/carbon up on these, so besides the throttle body, a thorough BG induction service is a good thing. Also... -
T
LR3 slight differential noise normal?
samnt650 PM replied. I can't necessarily say on the flush, but you are definitely due for a change. The flush is quite common in the UK. Houm nobody ever kicked themselves in the butt and said gee, I wish I had not maintained my vehicle so much. -
T
LR3 slight differential noise normal?
I read that elsewhere. No way to know for sure why, but it has worked for most folks, including myself. Let me know if you want better than OEM stuff... -
T
Front Windshield Leak
Ya, one of the write ups in mine. Here is the link remove the spaces. http :// disco3. co. uk/ forum/topic76762.html -
T
Is 320 miles good on a tank in Los Angeles city driving?
My city driving was down to about 11.5 mpg. I replaced all my o2 sensors and now I am at 13, much better on the highway, but I have not tracked that yet. The front drivers size sensor was seized, so the guys at my local shop had to drop the exhaust and repair the threads. For what it's worth... -
T
'05 LR3 Key Fob issue
bbyer has the part number if you have trouble drop him a PM I know he posted somewhere...
