Search results
-
Towing with 16 L405 Diesel
Sport Hitch will NOT fit the L405. You will need a VPLGT0083 bumper bar, LR036694 support bracket and VPLGT0074 harness,VPLGT0097, VPLGB0154, LR090834- under tray, foams, bumper cover, then you will need some 50mm and 40mm bolts. The kit from LRV is around $1300, you can piece together for less.- brad carlton
- Post #4
- Forum: Range Rover
-
Replacing heads on 2010 Range Rover Sport Supercharged
Did you have the tensioner ticking of death? 2010 is a common problem. There is a class action lawsuit you should research. Land Rover knows this is a problem until 2012. I was going to buy a 2012 but they couldn't verify the tensioner and guilds were replaced. Thats a 2k job, make sure you...- brad carlton
- Post #2
- Forum: Range Rover
-
Towing with 16 L405 Diesel
I just bought a trailer bar from a junk yard. It was $375 for just the rebar. Search for rear bumper reinforcement complete and you may find a whole setup. I find the junk yards throw away all of the good parts and sell only the bumper bar, why I do not know. I am told that you can use it but...- brad carlton
- Post #3
- Forum: Range Rover
-
‘06 Range Rover Sport HSE - air shocks
Arnott is way better than factory, AS-2809, Amazon has them for $260.00 each. Disconnect the battery, install new shock, reconnect battery. No calibration required. Sometimes you need to touch the pos and neg battery terminals together to reset air suspension or pull relay. Calibrate is a...- brad carlton
- Post #4
- Forum: Range Rover
-
Brembo upgrade on non-brembo HSE
I have an 3.0 Diesel HSE and the brakes are a bit to be desired. Low pedal feel and poor stopping quality. It brakes well, there are no vacuum problems, but "she is heavy" so who knows. I'm used to Jag Supercharged braking. Can I swap a Brembo setup from a SC Range Rover or Sport? Will they...- brad carlton
- Thread
- Replies: 0
- Forum: Range Rover
-
2010 RRSC Timing Chain Guide Going...
https://www.landroverworld.org/threads/timing-chain-repair-costs.30126/- brad carlton
- Post #2
- Forum: Range Rover
-
Help Requested with Suspension Issues with 2006 SC L322
Also, the suspension valve solenoid can sometimes fail. It should hold air and not allow it to back flow out of pump. A slow leak will refill upon start up but will wear out pump and cost you for a replacement at some point. Spray the top of air strut with soapy water and see if its leaking...- brad carlton
- Post #7
- Forum: Range Rover
-
Suspension creaking squawking
Sounds like binding sway bar bushings. Remove clamps, grease the snot out of the bushing with Long Life grease or Viper Lube and reinstall. Had this issue with my Jaguar and it was very annoying going over bumps at slow speed. Creaking and squeeking. Hazet offset wrench will probably reach it...- brad carlton
- Post #23
- Forum: LR4
-
Remove and replace supercharger snout
Which engine? I've done that on a 4.2 SC Jaguar.- brad carlton
- Post #2
- Forum: Range Rover
-
ECU controlled brake caliper pistons? L405
I just got an L405 Diesel. In reading, the brake R and R must be done with a computer to retract the caliper pistons? What is the most affordable program to get? Sounds like L405 technology is going to send me to the poor house at some point. I am used to doing most everything in my garage...- brad carlton
- Thread
- Replies: 0
- Forum: Range Rover
-
2016 TD6 engine longevity
Buying a 2016 HSE with 85k on the clock. I am a little concerned about the high miles. I am a Powerstroke 7.3 owner with +300k without any issues. Plan is to remove DFP and EGR. How are these motors long term? Anyone have one with some miles on it.- brad carlton
- Thread
- td6 tdi v6 diesel
- Replies: 1
- Forum: Introduction
