Recent content by mamesteco

  1. M

    Idler Pulley

    I cannot get your link to work.
  2. M

    Idler Pulley

    Goin' to work this morning and I thought I threw my serpentine belt. Found out the Idler pulley broke in half, fell off and I lost my belt tension. Just by chance I took the pulley off my wife's 01 Grand Prix to see if I could get it home. It worked, the inside bearing dimension was the same...
  3. M

    Driving lights

    I did and all I saw were wires going into the back of the housing. I guess I will just have to take one apart and figure it out. Thanks
  4. M

    Driving lights

    The factory lights under the bumper, in the plastic molding, controlled by switch under the clock in the dash.
  5. M

    Driving lights

    Driving/Fog lights 96 Disco. I have a factory driving/fog light burnt out. I haven't looked close at it yet, but do I have to remove the entire light to get to the lens part of the light to change the bulb? Or is there an easier way? My manual does not show the driving lights. Thought I...
  6. M

    Running/tailights and wipers?

    Sorry internet screwed up
  7. M

    Running/tailights and wipers?

    If I have a short, wouldn't it blow a fuse in my fuse panel? I have none blown.
  8. M

    Running/tailights and wipers?

    1996 Discovery I had posted before about my right side lights, tail lights and dash lights going out. Thought I had it fixed by replacing a couple of bad light sockets on my marker lights. Then about a week later, all marker and tail lights went out. Took the advice of the forum and got a used...
  9. M

    O2 schematic?

    Does anyone have a schematic for the rear O2 sensors, 96 Disco, 4.0 l?
  10. M

    O2 wiring

    Does anyone have a schematic for the rear O2 sensors, 96 Disco, 4.0 l?
  11. M

    O2 wiring

    I don't remember when I did the fronts. I bought new ones for the back, they are the ones that have no plug (cheaper). I have to solder my old plugs to the new O2 sensors. The wires are different colors. Just wanted to find where each wire goes where before I dig into them. My book shows ground...
  12. M

    O2 wiring

    Could someone tell me what wires go where on the rear O2 sensors on my 96 Disco. It is a 4 prong square plug, what color goes to where? The wiring diagram I have only shows 3 wires and only 2 O2 sensors. Thanks in advance.
  13. M

    Cold weather stalling

    Update: Still stalling New fuel pump (30 lbs at idle on regulator, 38lbs reg disconnected, no idle change) New fuel filter New front O2 sensors Cleaned MAF,Idle control, TPS New coolant temp sensor When it stalls I shut down for a couple of seconds and start back up, usually idles at a...
  14. M

    Dash lights/taillights FYI

    I recently had my dashlights go out along with my right side tailights. I did have headlights, signals,left hand tail/marker lights,brake lights and red back up lights. Here is what I found on my 96 Disco 1. - fuse #8 blown - rear marker light in bumper , bulb socket corroded - front...
  15. M

    Cold weather stalling

    I only disconnected long enough to see the pressure jump, I don't think the idle changed.

Latest posts

Members online

Forum statistics

Threads
36,287
Posts
218,335
Members
30,502
Latest member
heather8635
Top