Recent content by Easycool
-
E
2008 LR3 Sunroof control module replacement
You are "The MAN!" This is exactly what I needed. I can't thank you enough. Should be a snap to fix this baby now. -
E
2008 LR3 Sunroof control module replacement
Thank you so much for responding quickly to my request. I know it has been a long long time since your post. So, I'm guessing that you ground one side and put 12v on either side to rotate the motor either CW or CCW. -
E
2008 LR3 Sunroof control module replacement
Did you ever fix your sunroof issue? If so, what did you do? -
E
2008 LR3 Sunroof control module replacement
Can you please tell me how you "hotwired" the motor? I was able to open my sunroof, but now no power whatsoever, so I can hear a cli k each time I press any button, but nothing else. 2007 RR HSE Full size 4.4l jag engine petrol -
E
Open Sunroof
My manual states to hold the center lift button for 20 seconds. I held it for at least a minute and no response, just herd a cli k when I depressed the button. Nothing else. -
E
Open Sunroof
How can I check the guides? Do I need to remove the headliner? My sunroof opened 3/4 of the way, but now no power. No switch operation and no amount of holding any button works. You can hear a click each time any button is pushed. Fuse good, windows work OK. I will check the wiring on the... -
E
Rear brake job - ebrake in service mode?
Ok, 2 things, 1. Where can I find Bodsey's Bible and, 2. How do you put the ebrake into service mode? 2007 Range Rover Full Size 4.4l petrol. -
E
Radiator Not Properly Seated In Frame.
Hi folks! Recently, I've had my 2007 RR HSE 4.4l petrol vehicle engine replaced. The shop that did it did such a horrible job. They charged me 2 arms and a leg. I didn't ever want to go back to them for the repairs that are needed, so I'm fixing them a little at a time. Currently, the vehicle...- Easycool
- Thread
- lower radiator not seated.
- Replies: 1
- Forum: Range Rover
-
E
EAS blew up!
Does anyone happen to have a diagram of the hoses in the rear? My 07RR HSE settles to the bump stops overnight. I'd really appreciate it. Thanks, in advance. -
E
Move on or Fix
Just wanted to mention that I use Atlantic British for many of my parts. I have worked with David Furiari for parts, and Gehart for technical issues. Unfortunately, there are not many videos for the 2007 RR HSE. I have the All Data manual for my vehicle, but there is no suspension hose... -
E
Move on or Fix
So, I want to thank lr3tx for the invaluable information and video. I will look into mine to see if it is similar. I am not sure the compressor is failing since the front suspension is fine. I didn't notice any valve blocks. I also need to find a hose diagram from/to the compressor and... -
E
Season's Greetings from Mesa, AZ
Replaced the engine at a cost of $7,000+. Then, on test drive, front differential locked up and snapped the driver's CV Axle half-shaft. Not a good thing. These cars are a mechanical nightmare. Now the rear suspension leaks down to the bump stops over night. I have no idea where the valve...- Easycool
- Post #7
- Forum: Introduction
-
E
air suspension -- dumb question
Thanks guys. I got lost on the range rover forum. Need to find where I asked about the valve block. Not familiar with this site. -
E
Move on or Fix
So, remember5, would you please explain how to do a suspension revalibration? The engine on our 2007 RR HSE, so control arms, ball joints, and CV axle half-shaft replaced. Then I started getting suspension fault during Morning startups.
