I first put some WD-40 SPECIALIST RUST RELEASE PENETRANT SPRAY and let it soak overnight.
Then a 2 1/2lb Engineer's Hammer and a Punch Tool did the job for me. It took only 3 taps to "convince" axle shaft to go in.
Good luck!
My A/C stopped blowing cold. Everything "seems" to work.
I was going to add freon but I noticed that the pressure is very high, like almost 100 PSI high.
I made sure to run the engine, wait until it was at normal running temperature. Then I plugged in the gauge in the low line and it reads ~95...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.