gsxr's latest activity
-
gsxr reacted to Rover Range's post in the thread 2015 LR4 SCV6 75K miles - O2 sensor not reading on ECM with
Like.
What is the actual DTC that you are getting? Bank 1 #1 O2 sensor DTC, won't be cat related. Since it is upstream of the cat. -
When determining journal limits, diameter and new bearings needed, how the heck do I read the chart in the service manual to get real...
-
Machine shop called back and said the snout of the crank has a wobble of approximately .005" so I did not have it machined. I have...
-
Heads and block are nice and flat. Unfortunately, since rod bearings 1 and 2 spun, it seems to have given the crank nose a bit of...
-
gsxr reacted to Quijote's post in the thread Rigid brake line failed - need help with info on parts with Like.
I didn't find much info, so perhaps this thread will help others. It's been a while since I've been active primarily because we don't...
-
gsxr reacted to Quijote's post in the thread Rigid brake line failed - need help with info on parts with Like.
2nd update. I performed a brake flush with a motive pump (dry method). I did all 4 corners until new fluid came out with no bubbles. The...
-
gsxr reacted to Quijote's post in the thread Rigid brake line failed - need help with info on parts with Like.
I'll follow up my own thread for the benefit of others. In short, the fittings are M10x1 bubble (aka single flare) fittings. I did...
-
gsxr reacted to Quijote's post in the thread Rigid brake line failed - need help with info on parts with Like.
3rd update. Success! From researching, it seems I must have had air in the ABS module, which cannot be fixed manually. Luckily, the GAP...
-
I've done several brake bleeds on this car. It's no different than any other car. You can do it the old school way with someone on the...
-
gsxr replied to the thread LR4 brakes soft/hard.No strainer. There is a wire to the sensor integrated into the cap, the wire must be disconnected first. Then the cap comes out with a...
-
gsxr replied to the thread LR4 brakes soft/hard.Just completed a brake flush on the LR4 and figured I'd add some notes to this thread. I used 1 liter of Ate SL.6 fluid. After siphoning...
-
Further to this the v6 manual states “If the above fluid is not available, use a low viscosity DOT 4 brake fluid meeting ISO 4925 Class...
-
Since you can already handle a serpentine belt, this job should feel very familiar. Look for a belt routing diagram on a sticker under...
-
gsxr reacted to BBLR3's post in the thread LR4 Transmission Fluid Change: Pan Swap Option with Like.
My trans is starting to shudder a little bit again. I guess lubeguard will only get you so far, but as a temp work around, it definitely...
-
gsxr reacted to Quijote's post in the thread LR4 Transmission Fluid Change: Pan Swap Option with Like.
Just a minor update to fully close the loop, I am calling time of death on any possibility of leaks. The LR4 has not had some 100 mile...
