Michael Gain
Full Access Member From Clarksville, TN
- Joined
Latest activity Postings About
-
-
Michael Gain replied to the thread Rear Drive Shaft Replacement.Great find! -
This is what you seek...
-
Michael Gain replied to the thread Track width change from rim/tyre change.I'll start the fun. It's been a while since I've dug into the wheel / tire stuff. If I remember right, the compos have a lower offset...
-
Michael Gain replied to the thread Rear Drive Shaft Replacement.I replaced mine with GKN. No complaints. One inch of play is subjective. It depends how much force you are putting on the carrier...
-
Michael Gain replied to the thread First time front hub replacement and pic of damaged threads with advice needed..Some suspension nuts cut the thread as they are tightened. This prevents them from loosening. I've never seen one used on an axle, but...
-
Michael Gain reacted to avslash's post in the thread Dealership Multi-Point Inspection INSANE Recommendations! with
Like.
IMO, an out of warranty Rover should never darken the door of a dealership again. This makes me cringe, because my wife drives a 2016... -
Michael Gain replied to the thread P0170 fuel trim and CEL.May need a software update, brother. Worth calling the dealer to see if your VIN is part of a PCM update strategy. Other than that, I...
-
Michael Gain reacted to ryanjl's post in the thread What should I strip off this LR3 for spare parts for my LR4? with Like.
Nothing would **** me off more than doing all the work to change out a mechanical part only to find the part I replaced it with is 90%...
-
Michael Gain replied to the thread What should I strip off this LR3 for spare parts for my LR4?.They will fit just fine. It's been done https://expeditionportal.com/forum/threads/fender-flares.151659/ Here is the member on here if...
-
Michael Gain replied to the thread What should I strip off this LR3 for spare parts for my LR4?.Wheel arch trim--fender flares. Matte black is better than body color IMO.
-
Michael Gain replied to the thread 2015 LR4 having a meltdown at random times. Related to High Speed CAN BUS. Need help!.Not a problem at all. Yes. All of the car's modules communicate along the high or low speed canbus--between each other, receiving input...
-
Michael Gain replied to the thread 2015 LR4 having a meltdown at random times. Related to High Speed CAN BUS. Need help!.It's been awhile since I've been in the LR4 engine bay, but here is my advice. Check the driver-side battery box. The TCM is there; and...
-
Michael Gain replied to the thread 2016 LR4 Coolant Crossover, Water Pump, Thermostat Replacement.Please see attached
-
Michael Gain replied to the thread 2016 LR4 Coolant Crossover, Water Pump, Thermostat Replacement.No. That is the waste gate adjustment screw. If you unscrew it too far, you're likely to blow something. Let me find the adjustment...
-
Michael Gain replied to the thread 2016 LR4 Coolant Crossover, Water Pump, Thermostat Replacement.If it is still being difficult, just remove the bolt and pull the sensor out. It is one of the MAP sensors. On its shaft is a small...
-
-
Loading…
-
Loading…
