-
-
Pfunk951 reacted to gsxr's post in the thread How-To DIY: Replacing LR4 in-tank fuel pump with
Like.
Photos 6 through 10 of the VDO pump. (And why is my previous post awaiting moderator approval?) -
Pfunk951 replied to the thread Rear Ladders on LR4...All the Cool Cats run Firenze;) My advice: 1. Frontrunner, Gobi, or Stock. I've seen some new aluminum ones popping up on the...
-
-
Pfunk951 replied to the thread Write up: High Pressure Fuel Pump (HPFP) Replacement.Pump removal I’m not going to lie- it’s going to get tight here. We’ve got a frame rail right in the way, but plenty of room in front...
-
-
Gang, As we get up in miles, these pumps are sure to become an issue. I pieced together information I found on the web and did the job...
-
-
Pfunk951 replied to the thread Molle Plate for the LR4.Yes, I have one. Details: 1. Love it. 2. I installed with 3m double sided tape on the bottom brackets (which are 3d printed!), instead...
-
-
Pfunk951 replied to the thread Headlight oxidation....Also! Grab a roll of 3M protective film (don't get the pre-cut, too expensive and these headlights are easy) and wrap them after you...
-
Pfunk951 replied to the thread P0328 Knock Sensor.There you are! This was at Big Iron- absolutely amazing time.. The pump shot craps somewhere in North Oklahoma, made it back to the...
-
Pfunk951 replied to the thread P0328 Knock Sensor.Closing this one out for posterity- it was a High Pressure Fuel Pump..! These are on the same side of the engine as Bank 1, and must...
-
-
Loading…
-
Loading…
