Recent content by Wilfredo
-
W
Fuel Pump Dont operate
I remplaced the Crankshaft crank sensor $ 70.00 Check and operation was good thank for all -
W
Fuel Pump Dont operate
I already reset fuel cu off - 12vdc before and after switch Thank for the message from disco mike because i clean crank sensor electrical connection and then turn on the engine but after 3 minute start to give me a rpm erratic and then shut down like crack sensor intermittent failure i will... -
W
Fuel Pump Dont operate
Fuel pump relay Yes i swap the relay . I already have 12 Vdc on relay terminal #30 all time and 12 Vdc on terminal #85 when switch is on II position but only read 6 volt from 85 to 86 , and when i read from 85 to battery negative terminal i got 12 vdc -
W
Fuel Pump Dont operate
Master Swicth on position II i have 12 Vdc on pump relay but the ECM dont give me the ground to operate the relay. I jump the contact to send 12 Vdc to fuel pump and work perfect. somebody have any idea -
W
Abs Ecu Change
The same situation is happen to my Discovery II 2000, thank I let you know on future
