Disclaimer: Links on this page pointing
to Amazon, eBay and other sites may include affiliate code. If you click them and
make a purchase, we may earn a small commission.
Master Swicth on position II i have 12 Vdc on pump relay but the ECM dont give me the ground to operate the relay. I jump the contact to send 12 Vdc to fuel pump and work perfect.
somebody have any idea
Yes i swap the relay . I already have 12 Vdc on relay terminal #30 all time and 12 Vdc on terminal #85 when switch is on II position but only read 6 volt from 85 to 86 , and when i read from 85 to battery negative terminal i got 12 vdc
Pump is probably good, may have a bad crank sensor which if it has failed will not allow the ECU to engage the fuel pump and or the coils.
Check for voltage from the Cranks sensor when the engine is turning over.
I already reset fuel cu off - 12vdc before and after switch
Thank for the message from disco mike because i clean crank sensor electrical connection and then turn on the engine but after 3 minute start to give me a rpm erratic and then shut down like crack sensor intermittent failure i will replace the sensor and let you now
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.