Search results
-
*My LSx Swap LR3 Build (World's First)
Cool i love out of the box thinking -
Tools for LR3
This is the one i have and it works on all types from my f350 diesel to my audi -
Tools for LR3
Its strictly a reader but it gives code info and can stream real time info it can go into the engine ecu and tcu it cost like 20.00 -
Tools for LR3
Cheap multi meter a set of 1/4" sockets and a set of 3/8" metric sockets. I would also contemplate a spring clamp plier but not neccesarry just very useful a elm wifi code reader Good jack and stands oil catch pan and some brake kleen -
Indy shop says I need a new engine
Yeah that is pretty disheartening. If the crank sensor was faulty it wouldn't spark either tho have you done a fuel press test ? -
Indy shop says I need a new engine
Well he can check the cam and crank alignment marks. Or Take #1 cylinders plug out put it at TDC and see if the crank lines up. I mean it could be a faulty injector washing the cylinder wall so it doesn't seal -
05 LR3 Parking Brake Fault/ Transmission Fault
Could it be your shifter mechanism is sticky like the gear selector to manual make sure its all the way centered and that the pbrake switch is all the way retracted -
What is y'alls MPG?
I am 16.2lper 100k i am going to be going a cat delete and exhaust in a week so i will post any changes and sound if interested That's 13 ish in mpg -
06 lr3 cranks wont start when wet
Hhm weird you could try accessing you engibe wire harness and mist it a bit in an area the try and start and so on. But I would have a good look for at you ignition wires or your crank sensor wires or connector if water find a lil brake and shorts the ignition fire sense signal it won't start... -
-
AC problems
No you won't have a rear blower then try looking under the passenger dash usually its there. Normally its a round fan like a hamster wheel drivel by a electric motor that will have 2 decent sized wires going to it. Normally you can take 4or 5 screws out that mount the fan up into the heater... -
AC problems
Yes could be the blower motor got something stuck in it and burnt out. Can you hear the fan going at all and also check your rear unit as well -
Off centre wheel after suspension work
It should be back to Center after the alignment -
Suspension issue 2005 LR3
And isn't there a better option for us for pumps ? -
Suspension issue 2005 LR3
Remove the temp sensor it should just unscrew and hold it away from the housing and see if it helps also do a continuity check maybe it has. Melted due to intense overheat. -
Removing the cat's
Hi just wondering if anyone has done this and if you can just weld a spacer bung on the rear o2 to get rid of the CEL light. I am doing a trany filter service and need a muffler change anyways so just thought i might as well bend up a couple pipes at the same time Thanks in advance -
AC blowing warm air
I just fixed mine i had a bad oring on the high pressure side at the joint on the drivers side just forward of the rear tyre by the rocker panel its viewable from underneath -
G10 or a10?
Hello everyone and thanks for the time to look at this thread. Ok so i have just got a lr3 and i am trying to figure out the dvd system i have is a single roof mount rosen system i cant get sou d to play thru the stereo or headphones i have herd anout some aux plug ? Is this simply a 3.5mm jack... -
Hello everyone
Hello to everyone out their i am new to the LR scene but use forums alot and i am going to be adding a lr3 to my line up if vehicles :) Looking forward to sone fun Sent from my iPhone using Tapatalk- waspjr123
- Thread
- Replies: 1
- Forum: Introduction
-
aftermarket stereo problem
I am sure their is a way to bypass this and like ^ he said probs need a new amp to get full potential out if the stereo Sent from my iPhone using Tapatalk -
Looking at a lr3
Hello all i am looking at a 2005 lr3 hse anything i should look out for? Thanks everyone and merry xmas as well Sent from my iPhone using Tapatalk- waspjr123
- Thread
- Replies: 1
- Forum: Introduction
-
New to lr3 what to look out for when buying
Hello all i am looking at purchasing a 2005 lr3 hse and i was just wondering what should i look out for? Also what kind of scan tools should i use? I am a licensed mechanic. Thanks before hand Cheers :) Sent from my iPhone using Tapatalk -
Just new to the LR experience what to look out for
Hello everyone i need some insight on a 2005 lr3 hse. I am going to be purchasing a lr3 and i wanted to see if anyone could shed a helpful tip on what to look for. A lil background on myself is that i am a licensed mechanic and i will be doing everything myself. Also i live in the mountains and...
