21,000 is about the time I needed front brakes / rotors. I went with EBC, I got 80k out of those rotors. You will need to do some detective work to identify where the squeak is coming from.
Take it to the dealer, let them resolve this issue. There is also an upgrade tank seal. Mine was smelling like gas for awhile and I took it in. After a flatbed and redo issue was resolved. The piping is pretty complicated for all that stuff.. This is one of the few items I would leave for the...
It would get worse. My local independent put it on a lift, and used something to see how much play it had in it to see if the CV was ok.
Could be wheel bearing / hub as well. Do you have a decent independent, where are you located?
The suspension light might also be caused if a height calibration and alignment was not done. You can walk around and eyeball it for heights and see if it looks the same, or there is a big difference. Mismatched tires can cause the problem, as mentioned above, the height sensor thing.
Buy your own genuine parts, lucky8 or landrovermerriumparts and take them to a good independent if you don't have the right stuff.
The original lower arms were upgraded slightly, and the ball joint is bigger. Rebuilding them, is very labor intensive.
Wow, you've been pretty thorough. It doesn't seem like there is much left. While we are waiting for other suggestions why don't you post a how to replace the items you've replaced?
Does the vehicle also have the rear AC unit?
Does it rain allot there?
Water in the cabin?
Shorts in wiring?
Let's start here...
I am guessing you've got lower front suspension bushing arms worn, it's a common issue.
The videos on the channel have sound identification videos that are extremely useful.
http://www.youtube.com/user/jjvd21/videos
I paid the dealer some 500.00 to clean the throttle body a couple of years ago. As I drove home, the light came on. So I went and bought a can of sea foam, dumped in in the tank (full) and drove it. Eventually the light went off, it has been off ever since. I try to dump a can in every couple...
I had a similar issue when removing a fitting a new compressor. It's not the new one. I did some checking and there was contact with the slider and compressor because the wrong bolts were used. If you can reach up there and hold the compressor and make it stop, then probably it should be...
You can read through the links I provided. I believe some of them can be replaced, and the 2nd link has pictures. Also, when the dealer does it for you, they should be installing a new top ring / seal which is upgraded. You should be careful the first fill up, to be sure it does not leak, or if...
It should not be temperature related.
Worn shorting wire, sensors. The sending unit is in the tank, so run the fuel tank low and take it to a dealer would be what I would do.
http://www. disco3. co. uk/forum/topic83097.html?highlight=Fuel+gauge
http://www. disco3. co...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.