Search results
-
maintenance history since new 2013
Dang. I thought my $19,000 and change was high (that includes Renan engine) you clearly win! -
Persistent P0430 on my 2012 5.0
No, how do I do that with the gap tool? -
Persistent P0430 on my 2012 5.0
lol tried it now I’m getting a lean code. It never stops with this POS. -
Coolant Tank / Cap Question
My original expansion tank developed a leak so I picked up a replacement off Rock Auto that included a cap. Odd that the cap is rated 110kpa instead of 200 like the original. Should I swap caps? -
Dash lit up like a Christmas tree out in BFE
My LR4 has lit up like a Christmas tree 3-4 times randomly. Invest in a gap tool. It’s always resolved the issue. -
I think it's time to move on...
I’ve got 40k miles on my reman. Not too shabby - where’d you order from? -
My LR4 experiences in terms of mechanical issues that keep piling up
Same. Engine swap alone was more than $10k. -
Persistent P0430 on my 2012 5.0
I’m giving those a shot as I don’t believe the cat is faulty. I’ll replace it next month if need be. I know I’ve got an exhaust leak on that side. Bank 2. -
Persistent P0430 on my 2012 5.0
Crossover busted doing 80 on the interstate (prior owner) by the time he was able to pull off the road the engine was cooked. -
Persistent P0430 on my 2012 5.0
2012 LR4 190k miles, 40k on reman engine. Recently developed P0430 code. Ran 2 cans of Cataclean and still comes back after I clear it with my GAP. What diagnostics can I do (GAP Gen 1 no BT) to figure out if I need a new cat? -
LR4 - Coolant Under Pressure When Cold
What did you end up doing after further diagnosis? -
C1A13-64 fault code fix
I started with an intermittent suspension fault every couple of days, typically when parked on an incline. Eventually the code became more prevalent and would often pop up when driving over the past week. Today, I went to YouTube and found the following video: I figured it wouldn’t... -
LR4 - Coolant Under Pressure When Cold
Used engine prices have come down, and remans are around 12-15k installed. -
Suspension Fault When Parked on Incline
Appreciate the insight, I plan to clean the desiccant and exhaust then I’ll flash the firmware as you mentioned. -
Suspension Fault When Parked on Incline
Once I move the rover to flat ground, turn it off and turn it back on. The code goes away. -
Suspension Fault When Parked on Incline
C1A13-64 Pressure does not decrease when venting the gallery -
Suspension Fault When Parked on Incline
I will park on an incline, pull the codes and report back -
Suspension Fault When Parked on Incline
2012 LR4 just started throwing a suspension fault when parked on a steep incline. Only happens when parked nose up on hefty grades… Any ideas? -
Front driveshaft bolts went missing!! And an introduction
My suggestion is to use Loctite on reassembly. -
Front driveshaft bolts went missing!! And an introduction
My 2012 did the same. -
DIY Replace Third Brake Light on Tailgate LR4
Appreciate the write up, this gave me the inspiration to tackle the job today! Apparently I had an awesome scraper tool BC removing the old adhesive only took about 15 mins. The hardest part for me was getting the courage to use the windshield adhesive. That’s some seriously sticky stuff... -
-
AC not cooling - B11FF-85 (2E) code
My pressure reading according to GAP -
AC not cooling - B11FF-85 (2E) code
Apparently there’s an issue with air conditioner refrigerant pressure according to my GAP tool. Any idea what causes this or potential solutions? -
Front propshaft / driveshaft replacement
185k miles and there’s a popping / clicking noise when under load either accelerating or decelerating. Drivetrain vibration around 50-55 mph
