Search results
-
P0526-17 (28) Fan speed sensor circuit - General electrical failure - circuit voltage above threshold
I tried looking up that DTC in the LR manual. Doesn't come up. Make sure that the fan is spinning "freely." If the motor mounts are sagging, the fan can drag on the fan shroud brushes.- Rover Range
- Post #2
- Forum: LR4
-
Brake Fluid
You won't notice any difference between the fluids. DOT 4 meets the requirements.- Rover Range
- Post #3
- Forum: LR4
-
-
Water leaking just started yesterday, HELP
Be sure to check the rubber elbows on the drain hoses. They are in the front footwells where the drain hoses exit the vehicle. VOLVO part # 30753148 is a direct crossover part.- Rover Range
- Post #10
- Forum: LR4
-
2010 LR4 Air suspension need advice
No need to change the desiccant. Top mounting bolt: Use a long extension with a swivel 10mm socket.- Rover Range
- Post #29
- Forum: LR4
-
C1130-66 Air Spring Supply
TTM can be initiated by a sequence of door opening and brake pedal application. May have been inadvertently activated. Normal suspension mode is reactivated, once you drive over 30mph.- Rover Range
- Post #5
- Forum: LR4
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
Oil pressures are as follows: Idle 68F (temp) 29psi 1,500 rpm 68F 87psi 3,000 rpm 104F 90psi 3,000 rpm 230F 72psi 3,000 rpm 266F 58psi Your Autel reading is 100. Which would be 100% duty cycle on the oil pump solenoid, commanded full open. Rev the engine up and see if that %...- Rover Range
- Post #8
- Forum: LR4
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
Don't just go replacing parts because of a DTC. That oil pump requires complete engine disassembly. I have yet to see one of those oil pumps fail.- Rover Range
- Post #4
- Forum: LR4
-
Electric Oil Pump Control Solenoid on a 2016 3.0l?
a) Autel probably giving incorrect DTC. b) The solenoid is integrated with the oil pump. The solenoid opens a passage at low rpms to reduce oil pressure. Which is intended to reduce fuel consumption.- Rover Range
- Post #2
- Forum: LR4
-
C1130-66 Air Spring Supply
C1130-66 indicates that the suspension is in tight tolerance mode. Used when doing alignments. The other two are "ghost codes." I would disconnect the battery for 15min, reconnect and see what happens.- Rover Range
- Post #2
- Forum: LR4
-
Break in the MOST ring? Fiber optic interconnect
Land Rover dealerships have a repair kit for the fiber optic cables. Basically inserting a male and female connector where the break is.- Rover Range
- Post #9
- Forum: LR4
-
2011 LR4 Suspension code U3000-1D
What is your VIN #? I can look up the DTC and let you know the next step.- Rover Range
- Post #6
- Forum: LR4
-
2010 LR4 Air suspension need advice
White residue will be in the air lines.- Rover Range
- Post #26
- Forum: LR4
-
Smart Key low battery on Clusterboard still shows warning, even though I have changed the battery on the FOB. Any suggestions?
Sometimes , with the engine running, you can push the unlock button on the fob two times.- Rover Range
- Post #2
- Forum: Range Rover
-
Transmission Heat Shield
TSB for the LR4 is, LTB01207 Renew bracket and install foam pads as shown.- Rover Range
- Post #12
- Forum: LR4
-
Tailgate open error
Could be a bad pin switch in the upper tailgate latch.- Rover Range
- Post #2
- Forum: LR4
-
LR4 Window problems
With the engine running. Windows closed. Lift up on the window switch, hold for 5 seconds and release. Repeat once.- Rover Range
- Post #6
- Forum: LR4
-
Rangerover l322 suspension fault
You have an air leak somewhere.- Rover Range
- Post #2
- Forum: Range Rover
-
Control arms debacle
Believe it or not. I've see it before. The arms were swapped and upside down. The arms should slip right into the frame mounts when installing.- Rover Range
- Post #4
- Forum: LR4
-
-
Anyone swapped out for newer seats?
At a quick glance, the seat frame mounts look the same.- Rover Range
- Post #3
- Forum: LR4
-
LUX vs Vision package
Send me your VIN # and I get you the official Land Rover build list.- Rover Range
- Post #8
- Forum: LR4
-
Tensioners - (for the timing chain) - what's the deal?
2013 on up models have the revised chain guides.- Rover Range
- Post #17
- Forum: LR4
-
Fuel pressure regulation
The timing marks on the fuel pump drive sprocket has to line up with the colored link on the chain. Did you use the timing tool at the vacuum pump?- Rover Range
- Post #6
- Forum: Range Rover
-
Milling....
Any decent machine shop will know the maximum that they can machine off the head gasket surfaces without causing issues. Land Rover doesn't recommend machining the block and heads, that you would need thicker head gaskets. The cylinder liners are Nikasil. If that liner is machined, the Nikasil...- Rover Range
- Post #5
- Forum: LR4
