Search results

  1. 16FujiDisco

    DIY water pump and crossover pipe Video.

    I listed it on my post a few back
  2. 16FujiDisco

    DIY water pump and crossover pipe Video.

    @go_jesse here are the parts I just used for my '16. These should be the same for all SCV6 years: Thermostat - LR117568 Oil cooler o-ring - LR030593 Oil cooler line - LR028136 Water pump - LR097165 Bleeder valve cap - LR011038 Front crossover pipe - LR090630 Rear crossover pipe - LR122710 Y pipe...
  3. 16FujiDisco

    Another LR4 Saved from Coolant Death

    Having just done mine and having zero LR experience prior, I can say the whole process was pretty straightforward. The actual parts for the crossover pipes are easy to do and can't be mistakenly put wrong.
  4. 16FujiDisco

    P0030-00 (68) Heated Oxygen Sensor Circuit Malfunction

    There is a TSB for O2 sensors having issues and it will diagram which location; bank 1 has 3 and bank 2 has 3. I had a similar 02 sensor code and bought a replacement, but it went away when I changed my pcv valve. Mine is a '16 with around 67k mi
  5. 16FujiDisco

    Another LR4 Saved from Coolant Death

    Whomever you let do it, do it all. I've been stranded by a valve cover gasket leak that ended an alternator, and let me tell you it's no fun. From my short experience, no auto parts stores carry LR parts in stock. If the alternator looks caked with oil/grime, replace it too. Also make sure the...
  6. 16FujiDisco

    5.0 supercharged into an LR4?

    We'll if @Tapps33 found out that having the other modules would fool the new ECU into thinking its a RRS, then it may be that simple for us SCV6 folks. We "should" have all of the same sensors/modules for the engine to operate as the SCV8, so a re-write of files may me the ticket. It would be...
  7. 16FujiDisco

    Transmission crud on pan magnets

    I like to think of excess fluid dripping as weed control on my gravel driveway :laugh:. For real though, I figured as much; it wont be the first trans pan I've dropped or the first trans fluid bath I've had. Those clothes go straight to the trash....
  8. 16FujiDisco

    5.0 supercharged into an LR4?

    here's this regarding v6/v8 comparison; essentially the same block casting just with smaller cylinder bore/stroke for the scv6: https://www.caranddriver.com/news/a15349070/block-party-creating-a-v-6-by-declaring-two-cylinders-redundant/ My thinking is that this would be a much easier swap on...
  9. 16FujiDisco

    5.0 supercharged into an LR4?

    Thinking about some time in the future when mine is paid off and it becomes a toy....would this project be a lot easier to do a s/c V8 swap on the '14-'16 yrs that have a s/c V6? more plug and play friendly since its basically the same engine?
  10. 16FujiDisco

    What oil are you using?

    I bought a 6 pack of these off Amazon for about $8 ea.; no issues so far with the paper media, but I replace every 5k miles. Is anyone running the filters with cloth media at the 15k mi interval?
  11. 16FujiDisco

    "Typical" failure mode for coolant parts?

    @jlglr4 I just did my rear pipe with the updated p/n; looked like the others I've seen in pictures and just like the old one I replaced (original). Not really sure what changed.
  12. 16FujiDisco

    Transmission crud on pan magnets

    @Michael Gain perfect, thanks! I've scoped it out the last couple of times I was underneath in preparation and it seemed pretty straightforward. I'll also keep in mind that the pan doesn't fully drain.
  13. 16FujiDisco

    Transmission crud on pan magnets

    @Michael Gain anything special need to be done when dropping the pan? You have (had) the 8hp70 right? I've got the new pan, fluid, and a small ratchet with T40 bit; just haven't found any info on special technique to getting the pan down.
  14. 16FujiDisco

    Trick to removing plastic intake plenum?

    I noticed mine had the same barb that wasn't being used when I had everything off the other day. The other part of the "Y" connects under the throttle body.
  15. 16FujiDisco

    Farewell

    @Michael Gain If you ever get the itch just scoot down I-24 and you can help me anytime.
  16. 16FujiDisco

    Another LR4 Saved from Coolant Death

    Having just done mine this weekend I would say it took about 6 hours for pipes, water pump and thermostat. I feel confident I could cut that time almost in half if i did it again today. There is a lot of time in figuring out what is connected where you can't see. Reassembly was so much quicker...
  17. 16FujiDisco

    Another LR4 Saved from Coolant Death

    67k on the clock for mine; looks like I'm just in time. Also did the rear pipe (still looked good), pcv valve (getting the lean code), water pump and thermostat
  18. 16FujiDisco

    Another LR4 Saved from Coolant Death

    I got a lot of mine from AutohausAZ FCP euro is another good source
  19. 16FujiDisco

    Fan clutch

    I think you're right @jlglr4 . Did some more driving today and it happens right at the 1200rpm mark. It also seemed to go away once I had been driving for awhile and everything was nice and warmed up. I just want to say how nice it is and how thankful I am the you all are a responsive group.
  20. 16FujiDisco

    Fan clutch

    Michael, any update on this cause? I'm on a trip in Tulsa and just noticed mine making a short vibration sound at initial takeoff. Goes away quickly at low rpm and I don't feel it in the wheel or floor or anything. It does sound like it's coming from the front right area though.
  21. 16FujiDisco

    HD Package or not HD Package, how to know for sure using TOPIx

    This is how I shopped for mine as well.
  22. 16FujiDisco

    Getting tires installed at Discount Tire - Lift Concerns?

    My Discount Tire location locks the suspension in crawl mode and uses floor jacks on each corner; not sure why. They use jacks on my Silverado as well.
  23. 16FujiDisco

    Has anyone reflashed their 3.0SC V6 aka Tune?

    Mine seems to do it after a sudden stop like when a stoplight changes faster than you anticipated and you have break hard. It will do it for a second when the rpms dip but then stabilize and be normal
  24. 16FujiDisco

    Has anyone reflashed their 3.0SC V6 aka Tune?

    It's not, but you only replace the outer portion of the crank pulley. The "main" crank pulley stays on and the outer pulley for the supercharger bolts on with 6 torx bolts. It is noticable lighter than the original despite being larger in diameter.
  25. 16FujiDisco

    Has anyone reflashed their 3.0SC V6 aka Tune?

    you mean the shaking at idle? My still has it; I haven't noticed any increase in idle rpm. Mine doesn't seem to do it all the time though, and I doubt the wife even notices.

Latest posts

Members online

Total: 273 (members: 1, guests: 272)

Forum statistics

Threads
36,767
Posts
223,383
Members
30,923
Latest member
16RRSportjyn

Share this page

Top